Cisco Implementing Cisco Application Centric Infrastructure - 300-620 FREE EXAM DUMPS QUESTIONS & ANSWERS

Which two hardware models are supported as fixed spine in Cisco ACI fabrics? (Choose two.)

A Cisco ACI is integrated with a VMware vSphere environment. The port groups must be created automatically in vSphere and propagated to hypervisors when created in the ACI environment.
Which action accomplishes this goal?

Refer to the exhibit. A tenant is configured with a single L3Out and a single-homed link to the core router called Core-1. An engineer must add a second link to the L3Out that connects to the Core-2 router. Which action allows traffic from Core-2 to BL-1002 to have the same connectivity as the traffic from Core-1 to BL-1001?

Refer to the exhibit. The Cisco ACI fabric has an egress L3Out from Leaf-101 and Leaf-102 to CORE-1. VLAN 102 is used to form the OSPF adjacency. The workloads must be migrated into EPG-101, and the static port binding is configured to Leaf-103 e1/1 with encap VLAN 101. An engineer completes the port binding and receives an MCP fault. Which action clears the fault?

What is the minimum number of APICs does Cisco recommend to deploy in a production cluster?

What happens to the traffic flow when the Cisco ACI fabric has a stale endpoint entry for the destination endpoint?

A Cisco APIC is configured to authenticate users by using RADIUS by default. The network administrator must ensure that the users can access the APIC GUI with a local account if the RADIUS server is unreachable. Which action achieves this goal?

A situation causes a fault to be raised on the APIC. The ACI administrator does not want that fault to be raised because it is not directly relevant to the environment. Which action should the administrator take to prevent the fault from appearing?

A Cisco ACI fabric must be integrated with the VMware environment. An ESXi host is not attached to the Distributed Virtual Switch (DVS). Two EPGs were created and associated with the VMM domain. An engineer was asked to configure the ACI environment to meet these requirements:
- The EPG contract is pushed to ACI leafs after the ESXi host is
attached to the DVS.
- The EPG contract is pushed to the TCAMs only when two EPGs start to
communicate.
Which immediacy settings accomplish these goals?

An engineer wants to monitor all configuration changes, threshold crossing, and link-state transitions in a Cisco ACI fabric. Which action must be taken to receive the required messages?

An engineer must configure a Layer 3 connection to the WAN router. The hosts in production VRF must access WAN subnets. The engineer associates EPGs in the production VRF with the external routed domain. Which action completes the task?

An engineer configures an L3Out in VRF-1 that was configured for Import Route Control Enforcement. The L3Out uses OSPF to peer with a core switch. The L3Out has one external EPG, and it has been configured with a subnet 10.1.0.0/24. Which scope must be set to force
10.1.0.0/24 to populate in the routing table for VRF-1?

Which device is the pervasive gateway shown installed on?

An engineer implements a configuration backup on the Cisco APIC. The backup job must meet these requirements:
- The backup must transfer the encrypted data to the remote server.
- The transfer must be resumed if the connection is interrupted
Which configuration set meets these requirements?