Avaya Specialist IP Telephony Implement and Support Elective - 132-S-911.3 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

A customer is having a poor voice quality in their VoIP deployment. Upon Avaya's recommendation, the customer uses the VoIP Monitoring Manager to measure one-way network delay between endpoints. What are three guidelines for the delay measurements? (Choose three.)

A. delay over 180 ms could be acceptable depending on customer expectations, analog trunks used, codec type, etc. B. ITU spec should be 250 ms or less C. 80 ms delay or less can yield the best quality D. delay over 250 ms causes "talk over" problems

Discussion 0

Correct Answer: A,C,D Vote an answer

Question 2

Which components are needed to stack an Avaya C363-PWR with a G700?

A. The G700 can not be stacked with a C363. B. one X330STK module, one X360STK module, one ivory-coloredoctaplane cables, one blackcolored octaplane cable C. two X330STK modules and two ivory-coloredoctaplane cables only D. two X330STK modules and two ivory-coloredoctaplane cables and a DC power supply

Discussion 0

Correct Answer: B Vote an answer

Question 3

Your customer is installing an S8300 media server as an internal Call Controller in a G700 Media Gateway. Within the gateway, a MM312 has been included for DCP telephones and a MM711 for analog telephones. The customer intends to connect 18 IP telephones. What hardware would you recommend for IP telephony connectivity?

A. a MM316 LAN Media Module B. a Power Over Ethernet switch C. a MM314 LAN module D. a MM760 VoIP engine

Discussion 0

Correct Answer: B Vote an answer

Question 4

The S8500 is the media server of choice when migrating from which two traditional setups? (Choose two.)

A. G3r with critical reliability B. G3si with standard reliability C. G3r with standard reliability D. G3csi

Discussion 0

Correct Answer: B,D Vote an answer

Question 5

When a TN2302 IP Media Processor is involved in a VoIP call, what would you expect to see as the output of the status station <ext> command?

A. the RTP sequence numbers should remain constant with each status command B. the RTP sequence numbers have nothing to do with voice audio on the IP Media Processor C. the RTP sequence numbers should increase with each status command D. the RTP sequence numbers should decrease with each status command

Discussion 0

Correct Answer: C Vote an answer

Question 6

In a Port Network using Center Stage Switch connectivity, which boards are required to enable Enterprise Survivable Servers (ESS) functionality?

A. MedPro and CLAN B. IPSI and CLAN C. IPSI andMedPro D. EI and CLAN

Discussion 0

Correct Answer: C Vote an answer