Avaya Ethernet Routing Switch Implementation and Maintenance - 3605 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

The Ethernet Routing Switch (ERS) 8600 switch includes a means to fine tune the memory resources by allowing the record allocations to be allowed. An ERS 8600 running Release 5.0 needs to be configured to be optimized for multicast traffic. Which command alters the ERS 8600 to increases the default allocation of Multicast by 50 percent?

A. Config sys set multicast-resource-reservation 3073 B. Config sys set record record reserve MGID + 50 C. Config sys set show sys mgid usage D. Config sys set max-vlan-resource-reservation 4096

Discussion 0

Correct Answer: A Vote an answer

Question 2

A switch with Simple Loop Prevention Protocol (SLPP) did not detect a loop.
What are two reasons this occurred? (Choose two)

Discussion 0

Correct Answer:

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 3

A split Multi-Link Trunking (SMLT) for switch clustering is being configured.
Which statement is a configuration requirement for the SMLT?

A. Alternate the primary path of the SMLT connection to load balance the switch core. B. CP-Limit is configured on edge switch stacks. C. VLANS that are defined on the SMLT are so defined on the MLT that defines the core Inter Switch Trunks (IST) D. Neighboring edge switch stacks should be connected to each other via a DMLT connection to add resilient paths in the event of an SMLT failure.

Discussion 0

Correct Answer: C Vote an answer

Question 4

Syslog in the Ethernet Routing Switch (ERS) 8600 allows the mapping of ERS 8600 errors to specified to
be specified
to the
facility local 0-local 7.
What is another place of information that
syslog provides.

A. Security level B. System status C. Syslog table location D. Message frequency

Discussion 0

Correct Answer: A Vote an answer

Question 5

A technician has complied me configuration of an Ethernet Routing (ERS) 5520 to and now must transfer a backup copy of configuration file to server. Which command is used to accomplish this task?

A. 5520-24T-PWR# copy config scp filename ersS520conftg.cfg B. 5570-74T PWR# copy config tftp filename ers5520COnfig.cfg C. 5520.24T-PWR> copy config ftp filename ers5520 config.cfg D. 5520-24T-PWR# copy config ftp filename ers5520config.cfg

Discussion 0

Correct Answer: B Vote an answer

Question 6

What does Ping snoop identify?

A. Rate limiting for ICMP traffic B. The rate of IP traffic flow C. The path that IP traffic takes over an MLT or SMLT D. Which port filter is best to use on MLT networks

Discussion 0

Correct Answer: C Vote an answer

Question 7

In a unified access solution that supports mobility, the configuration must allow for the creation of mobility tunnels to the remote switch and needs the reservation of a remote switch in mobility solution?

A. The
remote switch
dynamically creates,
adds and removes VLANs as required in a mobility solution. B. Mobility
tunnels
are
created
when needed and
mapped to pre-configured existing static VLANs. C. Remote VLANs are dynamically created and will only contain tunnels. D. Remote VLANS are created with a valid IP address to the tunnel mapping based on the source network.

Discussion 0

Correct Answer: A Vote an answer

Question 8

The goal of the Converged Campus architecture is to provide a highly reliable infrastructure with sub second failover preventing any interruption of traffic on the network. HMD primary benefits of this design goal? (Choose two)

A. in the event of a failure, no loss of connectivity or application availability will be experienced by the end user B. The architecture provides high performance Layer 3 switching, resiliency, security, and services. C. This design goal provides numerous connectivity options including Asynchronous Transfer Mode (ATM), Packet over SONET (POS) and 10 gigabit Ethernet. D. The ability to provide hitless software upgrades for the core of the network.

Discussion 0

Correct Answer: A,D Vote an answer

Question 9

Which set of procedures will upgrade the boot monitor on an Ethernet Routing Switch (ERS) 8600 with a single 8692SF module?

A. Copy the new image to flash. Modify the boot choice for run-time image. Boot the new image. B. Copy the new image to flash. Modify the boot choice for run-time change. Activate the new image SF module in service. C. Copy the new image to flash. Boot the new image. D. Copy the new image to flash. Activate the new image with SF module in service.

Discussion 0

Correct Answer: C Vote an answer

Question 10

Which two pairs of commands will configure spanning tree on the edge switch? (Choose two)

A. 5520-24T (config) # interface fastethernet 25-26 5520-24T (config-if) # spanning tree learning disable B. 5520-24T (config) # interface fastethernet 1-20 5520-24T (config-if) # spanning-tree learning fast C. 5520-24T (config) # interface fastethernet 25-26 5520-24T (corrfig-if) # spanning-tree learning fast D. 5520-24T (config) # interface fastethernet 1-20 5520-24T (config-if) # spanning tree learning disable

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 11

Refer to the exhibit.

Based on the command line output shown in the exhibit, how many Gigabit Ethernet ports are available on this Ethernet Routing Switch (ERS) 8600?

A. 3 B. 48 C. 52 D. 83

Discussion 0

Correct Answer: B Vote an answer

Question 12

Which group of commands will configure Ethernet Routing Switch (ERS) 8600 to deny any source in the multicast group from reaching the multicast receivers connected to ERS 8600-B?

A. config ip prefix-list "2" add-prefix 238.1.1.0/24 config vlan 2 ip igmp access-control
2 create 172.3.1.0 255.255.255.0 deny- tx B. config ip prefix-list "2" add-prefix 10.1.1.0/30 config vlan 2 ip igmp access-control
2 create 172.3.1.0 255.255.255.0 deny- tx C. config ip prefix-list "2" add-prefix 238.1.1.0/24 config vlan 2 ip igmp access-control 2
create 194.4.10.0 255.255.255.0 deny- tx D. config ip prefix-list "2" add-prefix 192.4.0-0/12 config vlan 2
ip igmp access-control 2 create 172.3.1.0 255.255.255.0 deny-rx

Discussion 0

Correct Answer: A Vote an answer

Question 13

Based on the command line output shown in the exhibit, how many Gigabit Ethernet ports are available on this Ethernet Routing SwitchlT (ERS) 8600?

A. 24 B. 28 C. 26 D. 16

Discussion 0

Correct Answer: D Vote an answer