Avaya Aura(TM) Communication Manager and CM Messaging (R6.0) Implementation - 6002-1 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

Which three procedures are used to determine whether a gateway with a survivable remote server has lost its H.248 link (connection) to the main (Primary) servers? (Choose three)

A. Execute the SAT command List media-gateway from the remote survivable server, to determine whether the media gateway is registered with a survivable server B. Execute the Communication Manager command display alarms, to see whether the Link Loss Delay timer has expired C. Execute the SAT command status media-gateways, to determine which media gateways are not registered to the main server D. Execute the command status H.248 line from the remote gateway, to determine whether the link to the main server is active E. Execute the Communication Manager command display alarms, to see whether the No Service Timeout Timer (NSTT) has expired

Discussion 0

Correct Answer: A,B,C Vote an answer

Question 2

A newly installed main Cm 6.0 server indicates it is in license error mode. A technician again 45 minutes later and it is still in error mode. The license was installed from the system management interface (SMI)?
Which statement describes the reason for the error mode?

A. The installer used the wrong interface to install the license and it is therefore not installed. B. The installer loaded a license for one of the survivable servers, not the main server, and the IPSIs, media Gateways, and/or IP phones have registered to it C. The server cannot communicate with the IPSI or media gateway whose serial number was used in the license file. D. The license audit runs every 60 minutes and the error will be resolved in 15 minutes.

Discussion 0

Correct Answer: A Vote an answer

Question 3

Which three servers can be upgraded to communication manager Release 6.0? (Choose three)

A. S8300C B. S8510 C. S8300D D. S8800

Discussion 0

Correct Answer: B,C,D Vote an answer

Question 4

Which Ethernet port on S8800 server is connected to the customer network?

A. ETH0 B. ETH3 C. ETH2 D. ETH1

Discussion 0

Correct Answer: A Vote an answer

Question 5

Which three are tests that can be performed to Verify a communication manager Messaging 6.0 application is working properly? (Choose three)

A. Check the messaging port status using the display port command B. Verify the hunt group status C. Perform message waiting indication test D. Check the messaging port status using the status port command E. Call the messaging Hunt Group

Discussion 0

Correct Answer: B,C,E Vote an answer

Question 6

For the Duplex S8800 servers running CM 6.0, by default which Ethernet port communication with IPSts?

A. Eth1 B. Eth2 C. Eth0 D. Eth3

Discussion 0

Correct Answer: C Vote an answer

Question 7

A customer has selected Avaya Aura CM_survremote_embedded template.
Which Avaya server should be used?

A. S8300D Server B. S8800 Server C. S8730 Server 8Gb RAM D. S8510Server with 8GB RAM

Discussion 0

Correct Answer: A Vote an answer