Avaya 6002.1 Avaya Aura(TM) Communication Manager and CM Messaging (R6.0) Implementation - 6002 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

A newly installed main Cm 6.0 server indicates it is in license error mode. A technician again 45 minutes later and it is still in error mode. The license was installed from the system management interface (SMI)?
Which statement describes the reason for the error mode?

A. The installer used the wrong interface to install the license and it is therefore not installed. B. The installer loaded a license for one of the survivable servers, not the main server, and the IPSIs, media Gateways, and/or IP phones have registered to it C. The server cannot communicate with the IPSI or media gateway whose serial number was used in the license file. D. The license audit runs every 60 minutes and the error will be resolved in 15 minutes.

Discussion 0

Correct Answer: A Vote an answer

Question 2

A customer is planning to upgrade from CM 5X to CM 6.0 an existing 8510 server.
What is the total minimum memory requirement for this upgrade?

A. 4 GB RAM B. 8 GB RAM C. 12 GB RAM D. 16 GB RAM

Discussion 0

Correct Answer: B Vote an answer

Question 3

An administrator has just installed a 9620 IP Phones on an existing system. The command change IP network-map is use to administer the phone into to network region 100. All other phones are in network region 1. Like all other 9620 phones on this system, this one successfully gets IP address information fro, the one DHCP server. However, the new phone fails to register with CM.
Which two statements describe the cause of the problem? (Choose two)

A. There are no Medpros or H.248 Media Gateways administered in network region 100 B. On the IP interface form, some one recently set the field "Allow H.323 registration" to 'n' C. Network region 100 is not configured to communicate with other network regins D. Neither PROCR nor CLANs were administered in network region 100

Discussion 0

Correct Answer: C,D Vote an answer

Question 4

Which two hardware components support CM_survRemote template? (Choose two)

A. S8730 Servers with 8 GB RAM B. S8300D Server C. S8800 Servers D. S8510 Server with 8 GB RAM

Discussion 0

Correct Answer: C,D Vote an answer

Question 5

When using the Avaya Site Administration GSDI interface, which command would be use to built a new telephone set with the extension of 1000?

A. Add set 1000 B. Build station 1000 C. New station 1000 D. Add station 1000

Discussion 0

Correct Answer: D Vote an answer

Question 6

When troubleshooting a system fault, if the web interface or SAT are unavailable, which method should be used?

A. SAL B. MODEM C. TTY2 D. CLI

Discussion 0

Correct Answer: D Vote an answer

Question 7

Which Avaya G450 Module provides 8 DCP ports?

A. MM7202 B. MM711 C. MM712 D. TN2224

Discussion 0

Correct Answer: C Vote an answer