Alcatel-Lucent Multi Protocol Label Switching - 4A0-103 FREE EXAM DUMPS QUESTIONS & ANSWERS

A. Established LDP sessions run over a TCP connection. B. Frame mode requires multiple sessions between peers. C. The lower transport address initiates the session. D. An LDP session is established immediately after Init messages are exchanged between
peers.

A. eLER message B. iLER message C. Path message D. LSP setup call request E. Resv message

A. The path must define the LSP's tail end. B. The path may be used multiple times in a single LSP. C. The path may comprise loose hop entries only. D. The path may be used for multiple LSPs. E. The path must include at least one hop.

A. The bypass-node tunnel is used to avoid the next-hop downstream router 10.10.10.3. B. The router 10.10.10.1 is a PLR providing node protection for the router 10.10.10.3. C. The bypass-link tunnel is used to avoid the link with the egress interface address
10.3.4.4. D. One-to-one fast reroute protection is requested by an LSP.

A. Node protection tunnels are only used by one-to-one Fast Reroute. B. Link protection tunnels are established if a router is unable to establish node protection tunnels. C. Node protection tunnels can only be requested for a primary LSP path. D. Node protection tunnels detour around a failed next downstream router.

A. 60Mbps B. 10Mbps C. 20Mbps D. 70Mbps E. 30Mpbs

A. 10.1.4.78 B. 10.48.1.1 C. 10.32.1.2 D. 10.1.2.2

A. MPLS data traffic will be discarded until the IGP finds a new next-hop to router R3. B. MPLS data traffic will not be discarded because of fast reroute capability on router R2. C. MPLS data traffic will be discarded unless the LDP tunnel has a standby secondary path. D. MPLS data traffic will not be discarded because router R1 received labels from both next-hops, routers R2 and R3.