CWNP Certified Wireless Analysis Professional - CWAP-402 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

The To DS bit is set to 0 and the From DS is set to 1.
What best describes this 802.11 frame?

A. A frame being transmitted in a mesh BSS B. A frame being transmitted directly from one client STA to another C. A frame being transmitted from a client STA to an AP D. A frame being transmitted from an AP to a client STA

Discussion 0

Correct Answer: D Vote an answer

Question 2

You are using the real-time FFT display of a spectrum analyzer.
In what domain does this show the RF energy detected in the swept frequencies?

A. Time B. Length C. Frequency D. Phase

Discussion 0

Correct Answer: D Vote an answer

Question 3

While troubleshooting DHCP issues, you perform a protocol capture in order to determine if the DNCP pool is depleted. The capture does not show DHCPnak messages.
Where else could you look to determine if the pool is depleted?

A. AP logs B. DHCP server logs C. Spectrum analyzer D. Switch logs

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 4

When evaluating modulation and coding schemes, you must determine the best coding rate available. In 802.11 MCS tables, what is the best coding rate from the perspective of highest data rates?

A. 1/2 B. 3/4 C. 5/6 D. 2/3

Discussion 0

Correct Answer: C Vote an answer

Question 5

iPerf is a tool used in what category of testing?

A. Configuration B. Throughput C. Connection D. Name resolution

Discussion 0

Correct Answer: B Vote an answer

Question 6

You have been asked to recommend a solution for protocol capture of 802.11 frames consisting of 3x3:3 802.11ac communications. The requirement specifies that you gain a general view of a coverage area and does not require that you capture from specific user locations. The solution must be the least expensive practical solution possible that does not disrupt user access to the WLAN and it must be based on enterprise WLAN hardware.
What solution would you recommend so that any coverage area could be monitored on demand?

A. Install the minimum number of Aps required for coverage and use these Aps for protocol analysis as needed B. Install laptop-based protocol analyzer near each AP C. Install sufficient Aps so that an AP can be taken offline to perform protocol analysis as needed D. Install Wireshark on the Aps natively to allow dynamic capture while serving clients

Discussion 0

Correct Answer: D Vote an answer