Cisco Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0) - 200-105 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

What can be done to secure the virtual terminal interfaces on a router? (Choose two.)

A. Administratively shut down the interface. B. Create an access list and apply it to the virtual terminal interfaces with the access-group command. C. Enter an access list and apply it to the virtual terminal interfaces using the access-class command. D. Physically secure the interface. E. Configure a virtual terminal password and login process.

Discussion 0

Correct Answer: C,E Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 2

Drag and Drop Question
Drag and drop the routing protocols from the left onto the correct routing protocol types on the right.

Discussion 0

Correct Answer:

Question 3

What is the minimum level of SNMP that provides encryption?

A. SNMPv2 noAuthNoPriv B. SNMPv3 authPriv C. SNMPv3 noAuthNoPriv D. SNMPv3 authNoPriv

Discussion 0

Correct Answer: B Vote an answer

Question 4

Refer to the exhibit. RTA is configured with a basic configuration. The link between the two routers is operational and no routing protocols are configured on either router. The line shown in the exhibit is then added to router RTA. Should interface Fa0/0 on router RTB shut down, what effect will the shutdown have on router RTA?

A. A route to 172.16.14.0/24 will remain in the RTA routing table. B. Because router RTB will send a poison reverse packet to router RTA, RTA will remove the route. C. A packet to host 172.16.14.225 will be dropped by router R. D. Router RTA will send an ICMP packet to attempt to verify the route.

Discussion 0

Correct Answer: A Vote an answer

Question 5

Refer to the exhibit. Which address range efficiently summarizes the routing table of the addresses for router Main?

A. 172.16.0.0./16 B. 172.16.0.0./21 C. 172.16.0.0/18 D. 172.16.0.0./20

Discussion 0

Correct Answer: D Vote an answer

Question 6

Which type of VPN allows for one endpoint to be learned dynamically during tunnel negotiation?

A. site-to-site VPN B. GRE C. client VPN D. DMVPN

Discussion 0

Correct Answer: D Vote an answer

Question 7

Refer to the exhibit. What statement is true of the configuration for this network?

A. ExternalRouter must be configured with static routes to networks 172.16.1.0/24 and 172.16.2.0/24. B. The configuration that is shown provides inadequate outside address space for translation of the number of inside addresses that are supported. C. The number 1 referred to in the ip nat inside source command references access-list number 1. D. Because of the addressing on interface FastEthernet0/1, the Serial0/0 interface address will not support the NAT configuration as shown.

Discussion 0

Correct Answer: C Vote an answer

Question 8

For which reason can OSPFv3 fail to start between two routers?

A. IPv6 unicast routing is enabled. B. The interface assigned to OSPFv3 is in NBMA mode with only one neighbor defined. C. OSPFv3 is configured only under an interface. D. The router is configured with IPv6 addresses only and it is unable to find an OSPFv3 router ID.

Discussion 0

Correct Answer: D Vote an answer

Question 9

Which option is the master redundancy scheme for stacked switches?

A. 1:1 B. 1+N C. N:1 D. 1:N

Discussion 0

Correct Answer: D Vote an answer

Question 10

Which statement describes how the EIGRP feasible distance is calculated?

A. It is the best metric along a path that includes the metric to the neighbor advertising the path B. It is the sum of all K values in EIGRP process C. It is a path with a reported distance less than the current best path D. It is the total metric advertised by the upstream neighbor

Discussion 0

Correct Answer: A Vote an answer