Cisco Managing Industrial Networks with Cisco Networking Technologies - 200-401 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

What should be done with unused conductors in copper unshielded or shielded twisted-pair network cables?

A. splice to a used conductor B. trim back and properly insulate C. connect to protective earth D. terminate in their characteristic impedance

Discussion 0

Correct Answer: D Vote an answer

Question 2

Exhibit:

Which two statements are correct for a safe wiring installation to the terminal block of the switch or endpoint? (Choose two.)

A. Connect the positive 24 VDC conductor to the V terminal and connect the negative 24 VDC return wire to the RT terminal. B. Verify that the DC power circuit includes an overcurrent protective device that limits the DC current to 5 A. C. A ground wire can optionally be connected to the screw terminal on the front of the switch. D. Insert a green ground wire into the terminal block that is marked RT for return. E. Because this is a low-voltage DC circuit, anyone can install this wiring without electrical training or qualifications. F. Verify that DC power is live and within 24 VDC voltage range before starting wiring.

Discussion 0

Correct Answer: A,B Vote an answer

Question 3

Which two ports does EtherNet/IP use to communicate? (Choose two.)

A. UDP 2222 B. UDP 44818 C. TCP 44818 D. TCP 2222 E. UDP 502 F. TCP 502

Discussion 0

Correct Answer: A,C Vote an answer

Question 4

With a Cisco IE 2000 switch, what does a port status LED indicate when it is solid amber?

A. A link is present. B. The port is sending or receiving data. C. No link is present. D. There is a link fault. E. The port is not forwarding.

Discussion 0

Correct Answer: E Vote an answer

Question 5

What is a reason to use privileged EXEC mode on an industrial switch?

A. to configure VLAN parameters B. to configure parameters that apply to the entire switch C. to change terminal settings D. to verify commands that you have entered

Discussion 0

Correct Answer: D Vote an answer

Question 6

Which two commands can help you to determine what image is running on your industrial switch? (Choose two.)

A. show version B. show spanning-tree C. show interface-switch D. show interfaces gigabitEthernet x/y switchport E. show license

Discussion 0

Correct Answer: A,E Vote an answer

Question 7

What is the leading cause of fiber-optic link failure?

A. crushed fiber B. bad connectors C. poor testing practices D. contaminants

Discussion 0

Correct Answer: D Vote an answer