Cisco Implementing Cisco Data Center Virtualization and Automation - 300-170 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

You have a contract between in-band and out-of-band EPGs. Which two descriptions of this configuration are true? (Choose two.)

A. Management statics are available. B. Shared services for CPU-bound traffic are supported. C. The configuration supports Layer 2 filters. D. Filters apply in the incoming direction only. E. Both EPGs must be in one VRF.

Discussion 0

Correct Answer: D,E Vote an answer

Question 2

Which option must be configured to allow SNMP communications and traffic?

A. an out-of-band policy B. an out-of-band bridge domain C. an out-of-band management interface D. an out-of-band contract

Discussion 0

Correct Answer: C Vote an answer

Question 3

You plan to deploy Cisco ACI. You must provide the proper device package to integrate the Cisco APIC and the L4-L7 device of a vendor. Where can you get the package?

A. the Cisco ACI webpage B. Cisco TAC support C. the APIC repository D. technical support of the vendor

Discussion 0

Correct Answer: D Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 4

Which two parameters are part of the Cisco APIC first time setup and must be configured? (Choose two.)

A. the LLDP adjacency configuration B. the cluster configuration C. the APIC LLDP configuration D. the out-of-band management configuration E. the fabric node vector configuration

Discussion 0

Correct Answer: B,D Vote an answer

Question 5

Refer to the exhibit.

You must configure VXLAN on a Cisco Nexus 1000V Series Switch. Which command must you run on the port profile to encapsulate VXLAN traffic from the connected VMkernel interface?

A. encapsulation vxlan B. system vlan 100 C. capability I3control D. capability vxlan

Discussion 0

Correct Answer: D Vote an answer

Question 6

Refer to the exhibit.

Which description of the configuration of the Cisco Nexus 1000V Series Switch is true?

A. SVS mode is set to L3. B. VSM connects to the VMware vCenter server. C. Packet VLAN is a private VLAN. D. Mgmt0 is a Layer 2 interface.

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 7

Drag and drop the descriptions from the left onto the correct route controls on the right.

Discussion 0

Correct Answer:

Question 8

The behavior of which packet type can be controlled by selecting unicast mode or flood mode in a bridge domain

A. CDP B. ARP C. LLDP D. unknown unicast

Discussion 0

Correct Answer: D Vote an answer

Question 9

Which action occurs first when a device that has the POAP feature boots and cannot find the startup configuration?

A. The device installs a software image and a configuration file. B. The device obtains the IP address of a TFTP server. C. The device enters POAP mode. D. The device locates a DHCP server.

Discussion 0

Correct Answer: C Vote an answer

Question 10

Which two options are advantages of using AVS instead of a VMware vDS? (Choose two.)

A. AVS supports microsegmentation. B. AVS supports VLAN. C. AVS supports VXLAN. D. AVS provides a single point of management for networking. E. AVS supports vPath.

Discussion 0

Correct Answer: A,B Vote an answer

Question 11

Refer to the exhibit.

Which modules are shut down by the EEM power over-budget policy event?

A. All modules that have power over the budget shut down B. The modules starting from module 1 shut down when the available power drops below zero. C. The module that causes the power over-budget event shuts down. D. All modules shut down when the power budget is exceeded

Discussion 0

Correct Answer: B Vote an answer

Question 12

What occurs when the Cisco ACI fabric receives multidestination traffic?

A. The traffic is forwarded as unicast traffic. B. The traffic is suppressed. C. The traffic is forwarded as broadcast traffic. D. The traffic is forwarded as multicast traffic.

Discussion 0

Correct Answer: D Vote an answer