Cisco Implementing Cisco Threat Control Solutions (SITCS) - 300-207 FREE EXAM DUMPS QUESTIONS & ANSWERS
When you deploy a sensor to send connection termination requests, which additional traffic-monitoring function can
you configure the sensor to perform?
you configure the sensor to perform?
Correct Answer: A
Vote an answer
Refer to the following. What type of password is "cisco"?
Router(config)#service password-encryption
Router(config)#username admin password cisco
Router(config)#service password-encryption
Router(config)#username admin password cisco
Correct Answer: B
Vote an answer
SIMULATION




Correct Answer:
Steps are in Explanation below:
Explanation:
First, enable the Gig 0/0 and Gig 0/1 interfaces:

Second, create the pair under the "interface pairs" taB.

Then, apply the HIGHRISK action rule to the newly created interface pair:

Then apply the same for the MEDIUMRISK traffic (deny attacker inline)

Finally. Log the packets for the LOWRICK event:

When done it should look like this:


Explanation:
First, enable the Gig 0/0 and Gig 0/1 interfaces:

Second, create the pair under the "interface pairs" taB.

Then, apply the HIGHRISK action rule to the newly created interface pair:

Then apply the same for the MEDIUMRISK traffic (deny attacker inline)

Finally. Log the packets for the LOWRICK event:

When done it should look like this:


Which option describes what occurs with asymmetric routing when an IPS normalization engine is enable?
Correct Answer: C
Vote an answer
What is a difference between a Cisco Content Security Management virtual appliance and a physical appliance?
Correct Answer: D
Vote an answer
On which platforms can you run CWS connector? (Choose two)
Correct Answer: D,E
Vote an answer
Which sensor deployment mode does Cisco recommend when interface capacity is limited and you need to increase
sensor functionality?
sensor functionality?
Correct Answer: D
Vote an answer
During initial configuration, the Cisco ASA can be configured to drop all traffic if the ASA CX SSP fails by using which
command in a policy-map?
command in a policy-map?
Correct Answer: B
Vote an answer
Which two statements about devices within a Cisco ESA cluster are true? (Choose two.)
Correct Answer: A,B
Vote an answer
Which Cisco Cloud Web Security tool provides URL categorization?
Correct Answer: C
Vote an answer
With Cisco IDM, which rate limit option specifies the maximum bandwidth for rate-limited traffic?
Correct Answer: D
Vote an answer