Cisco Deploying Cisco Wireless Enterprise Networks - 300-365 FREE EXAM DUMPS QUESTIONS & ANSWERS
Clients on access points within an AP group are not receiving multicast traffic after roaming to another AP within the APgroup. Which configuration must be done to maintain multicast connectivity?
Correct Answer: C
Vote an answer
A customer has implemented an N+1 cluster of WLCs without using an AP high availability configuration and is experiencing an unacceptable delay when clients areroaming. Which two configuration changes can improve roaming? (Choose two.)
Correct Answer: A,D
Vote an answer
Your network is designed as a three-tier network model that contains core, distribution, and access switches.
QoS is implemented on the network. The access switch in a wiring closet is the only device that cannot reclassify packets. Where is the trust boundary?
QoS is implemented on the network. The access switch in a wiring closet is the only device that cannot reclassify packets. Where is the trust boundary?
Correct Answer: B
Vote an answer
Which CLI command does a wireless engineer use to display the maximum number of hops?
Correct Answer: A
Vote an answer
A network engineer has installed 802.11ac access points with80 MHz enabled; however, in the conference rooms, co-channel interference is being noticed. Under which tab in the RF profiles configuration can the engineer find the settings to tune the channel width for a group of APs?
Correct Answer: C
Vote an answer
You are configuring a Cisco WLC to support Cisco Aironet 600 Series OfficeExtend APs. Which two Layer 2 security options are supported in this environment? (Choose two.)
Correct Answer: A,B
Vote an answer
A customer recently implemented WLC wireless multicast. Clients and connecting at the highestmandatory wireless rate of 24 Mbps and are receiving multicasttraffic, but WLC cpu utilization and wired side network load has increased substantially. What three actions should the engineer take next to optimize the configuration? (Choose Three)
Correct Answer: A,C,D
Vote an answer
When CAPWAP protocol runs over IPv4, which UDP port numbers are used for control and data traffic, respectively?
Correct Answer: B
Vote an answer
An engineer must ensure that clients on an 802.1x WLAN can roam as fast as possible at a remote site that was deployed with FlexConnect. Which configuration ensures that this roaming occurs?
Correct Answer: D
Vote an answer
You are deploying a combination of Cisco Unified Wireless IP Phones 7921G and 7925G at your branch offices in a centralized call processing environment that requires high availability at branch locations. Which three components need to be verified before the wireless IP phones can be deployed? (Choose three.)
Correct Answer: A,C,G
Vote an answer
Refer to Exhibit.
A wireless client is connecting to FlexAPI whichis currently working standalone mode. The AAA authentication process is returning the following AVPs:
Tunnel-Private-Group-ld(81): 15 Tunnel-Medium-Type(65):IEEE-802(6) Tunnel-Type(64): VLAN(13) Which three behaviors will the client experience? (Choose three.)
A wireless client is connecting to FlexAPI whichis currently working standalone mode. The AAA authentication process is returning the following AVPs:
Tunnel-Private-Group-ld(81): 15 Tunnel-Medium-Type(65):IEEE-802(6) Tunnel-Type(64): VLAN(13) Which three behaviors will the client experience? (Choose three.)
Correct Answer: B,F,H
Vote an answer
You have set up FlexConnect APs. For which scenario is Fast Roaming supported, providing theWLAN is mapped to the same VLAN and the client is roaming to an AP on the same Cisco WLC?
Correct Answer: B
Vote an answer