Cisco Designing Cisco Enterprise Wireless Networks - 300-425 FREE EXAM DUMPS QUESTIONS & ANSWERS

An engineer is implementing a wireless design for a service provider. The design includes a Catalyst 9800, a stack of two Catalyst 9300X-48HX switches, and 9166 APs. Each AP must be named using the Floor-439412509-01X sting where X is the area number. The engineer wants to connect the APs to the switch stack using POE. How many APs must the engineer connect to the stack so the APs run using full functionalities?

An engineer has performed a predictive site survey for high-speed data and voice in an indoor office. What is the recommended data rate with -67 dBm signal level for optimal VoWLAN design?

An engineer must design a WLAN that can handle voice traffic and location-based services.
Which two design features enable both services to function properly? (Choose two.)

A customer has a single anchor WLC named Anchor A. Anchor A is in a DMZ and provides guest access. The customer wants to deploy an additional anchor controller named Anchor B to provide redundancy if Anchor A fails. Which design approach should be taken for the guest WLAN priority on the foreign WLC for each anchor WLC?

An engineer must perform a predictive design for a wireless network for location readiness and to mitigate interference. Which power level does the engineer use?

A community bank has three campus locations and one HQ with the data center operations. Each campus location has four Cisco Catalyst 9120 APs. The data center has a Catalyst 9800 WLC with eight Catalyst 9120 APs. Poor WAN uplinks cause impacted branch AP and wireless client connectivity back to HQ, and each campus location is now planned to have its own EWC controller based on C9120 AP to keep traffic local. This new design must accommodate these requirements:
- Guest WLAN will be routed locally.
- Employee WLAN must be authenticated 802.1x PEAP via HQ data center
ISE but can pass traffic locally once authenticated.
- HQ WLC will be the primary backup WLC for each WLC.
Which design approach should the consulting engineer take?

A wireless engineer is calibrating a floor using Cisco Prime Infrastructure. Which setting in the WLC must be disabled before the floor calibration is started?

After the completion of a site survey with Ekahau Site Survey tool, using the default color palette, it is noted that multiple areas are shown as white on the heat map when viewing 5 GHz signal strength data. What does this indicate about the signal strength?

A customer has a Cisco wireless network that has these configurations and components:
- two Cisco Catalyst 9800 Series WLCs in a high availability cluster
- 50 Cisco 2800I APs
- all SSIDs and services are 5 GHz only
A security mandate requires that rogue APs be scanned and identified in 2.4 GHz and 5 GHz bands and must not impact existing client connectivity. How must the wireless network be reconfigured to meet the requirement without purchasing additional APs?

What is the recommended cell overlap when designing a wireless network for Cisco Hyperlocation?

Refer to the exhibit A wireless consultant is performing an onsite survey using AirMagnet Survey PRO. What must be configured on the floor map so that the results appear properly?

Which feature must be incorporated into the network design to allow seamless Layer 3 roaming between controllers?

Refer to the exhibit. An engineer determined that during a recent controller failure, some APs did not failover to their secondary controller based on the network design, which has sufficient licenses for all APs. The controllers are not in a mobility group but have A records for their hostnames in DNS. Which setting needs to be addressed?

A network engineer is working on a design for a wireless network that must support data, voice, and location services. To support these services, which access point placement must the engineer use?