Cisco Implementing Cisco Service Provider Advanced Routing Solutions - 300-510 FREE EXAM DUMPS QUESTIONS & ANSWERS

What is a restriction of 6PE?

For which reason can two devices fail to establish an OSPF neighbor relationship?

A network engineer is troubleshooting OSPF multiarea.
Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?

Which two BGP mechanisms are used to prevent routing loops when using a design with redundant route reflectors? (Choose two.)

In Cisco IOS-XR, the maximum-prefix command, to control the number of prefixes that can be installed from a BGP neighbor, is configured under which configuration mode?

An engineer with an employee ID: 4535:15:507 must implement PIM-SSM in the network to support a new multicast messaging service. All the routers in the network run a distance vector routing protocol. Unicast routing is established on the network and is working normally. What must the engineer enable to continue the implementation process?

Refer to the exhibit. Dedicated MPLS Layer 3 services for VRF customer A are configured on the MPLS network for FTP access. OSPF with area 0 configuration is used as the interior routing protocol between the routers, and LDP is up and running on the MPLS network. After recent maintenance work on the MPLS network, IP address 172.16.100.1 cannot access the FTP server with IP address 172.16.192.21. All loopbacks are reachable on the network. Which configuration must the engineer apply to correct the problem?

What is determined by running the same hash algorithm on all PIMv2 routers?

Refer to the exhibit. An engineer is comparing these RPL and route map configurations. Which two conclusions will the engineer reach? (Choose two.)

Refer to the exhibit. After recent configuration changes to a customer's network, a network engineer notices that R2 cannot communicate with R3. Both FastEthernet interfaces on R2 and R3 are up and configured with the correct IP addresses. MD5 password configured on R2 and R3 match with no issues. What is the minimum change the engineer must make to enable R2 and R3 to communicate and fix the problem?

Refer to the exhibit. Multicast traffic destined from T1 and T2 routers to RP routers works well. A network engineer observes problems with multicast traffic flows between Site-A and Site-B. Site- A users fail to receive multicast stream on Site-B via RPTV site, while Site-B users fail to receive multicast stream on Site-A via RPTZ site. Which action must be implemented to resolve the issues?

The core routers within a transit AS are running both IBGP and IGP. The edge routers within the transit AS are using the next-hop-self option to establish the IBGP sessions. What can be implemented to improve the routing performance to all external prefixes?

An engineer warns to map a multicast IP address to a multicast MAC.
How many bits are used to make the conversion?

Refer to the exhibit. Networks 172.16.31.0/24 and 172.16.30.0/24 are advertised in area 34, and network 172.22.10.0/24 is advertised in area 0. A recent security review discovered that users connected to routers R1 and R2 have been making unauthorized access to an application running on network 172.16.31.0/24. An engineer determined that routers R1 and R2 are receiving updates for network 17.16.31.0/24. Which action resolves the issue?

Refer to the exhibit. PIM-SM has been enabled in the network, and the RP is located on R1 with IP address 20.20.20.1/24. After the team upgraded the networking stack on APP_Server with IP address 10.10.10.10/24, clients no longer receive the remote learning VoD resources.
APP_Server is assigned group address 224.0.1.40. Which action must the networking team take to resolve the multicast issue?