Cisco CCIE SP Written Exam, V3.0 - 350-029 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

A network engineer is implementing an MPLS network among devices from different vendors. The devices must be configured with MPLS VPN service and MPLS TE. Based on options provided, which three protocols fulfill all of these requirements? (Choose three.)

A. IGRP B. BGP C. TDP D. EIGRP E. LDP F. RIP G. RSVP

Discussion 0

Correct Answer: B,E,G Vote an answer

Question 2

Select the 3 best answers describing operation and configuration of Frame-Relay Inverse ARP.

A. Responses to Inverse ARP requests are entered in an address-to-DLCI mapping table on the router or access server which is used to supply the next-hop protoco address or the DLCI for outgoing traffic. B. Inverse ARP is enabled by default for all protocols enabled on the physical interface. C. Dynamic address mapping uses Frame Relay Inverse ARP to request the next-hop protocol address for a specific connection on its known DLCI. D. Inverse ARP in Frame-Relay is synonymous of ARP in Ethernet. E. Inverse ARP is configured using the following command under the Interface configuration 'frame-relay mapdlci (dlci number) protocol protocol-address'.

Discussion 0

Correct Answer: A,B,C Vote an answer

Question 3

In Cisco IOS XR Software Multicast Routing Implementation, which three features are
supported in IPv6 on Cisco CSR routers? (Choose three.)

A. Integrated multicast B. Aggregation multicast C. Multicast NSF D. PIM-Bidirectional E. PIM-SSM F. OOR handling

Discussion 0

Correct Answer: C,D,E Vote an answer

Question 4

A network engineer is redistributing BGP prefixes into RIP. These prefixes are unreachable in the RIP network. Which the two actions could resolve the issue based on this scenario? (Choose two.)

A. Enable internal BGP redistribution. B. Enable BGP AS-override. C. Rewrite RIP hop count for the redistributed prefixes. D. Enable BGP synchronization. E. Rewrite BGP next hop. F. Apply BGP next-hop-self.

Discussion 0

Correct Answer: A,C Vote an answer

Question 5

Refer to the exhibit.

XYZ is using the BSR method and PE1 has the configuration shown.

A. IPv4 MDT address family is not activated between PE1 and PE2. B. Loopback 3 is not enabled with PIM. C. A mismatch exists for update source interface between PE1 and PE2. D. A mismatch exists in MDT data subnet for XYZ VRF between PE1 and PE2. E. Which statement describes why PE1 is unable to receive RP information from XYZ site 2?

Discussion 0

Correct Answer: A Vote an answer

Question 6

Refer to the exhibit.

The exhibit illustrates the exchange of VPN route and label information between MPLS VPN inter-AS. The exhibit also shows ASBRs exchanging VPN-IPv4 addresses.
Which command is needed to change the next-hop address when ASBR2 is not configured?

A. Redistribute command with the BGP routing process B. Redistribute command with connected C. Redistribute command with the IGP routing process D. Redistribute command with static

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 7

Which two statements are correct?

A. A VC type 5 tunnels an Ethernet port over MPLS. B. A VC type 4 tunnels an Ethernet port over MPLS. C. A VC type 4 transports a VLAN over MPLS. D. A VC type 5 transports a VLAN over MPLS.

Discussion 0

Correct Answer: A,C Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 8

Which configuration prevents traffic that is sourced from the unique local address scope to be sent out of the link to the upstream service provider?

A. interface ethernet0/0 ipv6 traffic-filter NoULA out ! ipv6 access-list NoULA deny ipv6 FC00::/7 any permit ipv6 any any B. interface ethernet0/0 ipv6 access-group NoULA out ! ipv6 access-list NoULA deny ipv6 FC00::/7 any permit ipv6 any any C. interface ethernet0/0 ipv6 traffic-filter NoULA out ! ipv6 access-list NoULA deny ipv6 FC00::/8 any permit ipv6 any any D. interface ethernet0/0 ipv6 access-group NoULA out ! ipv6 access-list NoULA deny ipv6 FC00::/8 any permit ipv6 any any

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 9

When an MPLS Layer 2 VPN runs in the hub-and-spoke model, where is QoS implemented?

A. CE B. spoke C. hub D. hub and spoke E. PE

Discussion 0

Correct Answer: C Vote an answer

Question 10

Which MQC-based output queueing method is designed to support multiple traffic classes including VoIP traffic, mission-critical traffic, bulk traffic, interactive traffic and default class traffic?

A. Custom Queueing B. LLQ C. CBWFQ D. WRR Queueing E. CB-WRED

Discussion 0

Correct Answer: B Vote an answer

Question 11

Based on the following output in R1, which statement is truE.
R1#show mpls forwarding-table 50.0.0.3 detail
Local Outgoing Prefix Bytes Label Outgoing Next Hop
Label Label or Tunnel Id Switched interface
19 17 50.0.0.3/32 0 Et0/0 192.168.0.14

A. If a labeled packet arrives with the topmost label of 19, the label is replaced with label 17 and the packet is sent out on the Ethernet 0/1 interface. B. If a labeled packet arrives with the topmost label of 17, all the labels will be removed and a clear IP packet is sent to Next Hop 192.168.0.14 on Ethernet 0/0. C. If a labeled packet arrives with the topmost label of 19, the label is replaced with label 17 and the packet is sent out on the Ethernet 0/0 interface. D. If a labeled packet arrives with the topmost label of 17, the label is replaced with label 19 and the packet is sent out on the Ethernet 0/0 interface.

Discussion 0

Correct Answer: C Vote an answer

Question 12

What is the relationship between the Domain Name System (DNS) and LDAP?

A. All the root DNS servers maintain information in a distributed LDAP tree. B. DNS clients access DNS information by making LDAP queries to DNS servers. C. It is currently recommended to express DN as a sequence of Domain components D. An LDAP DN attribute is a Domain Name.

Discussion 0

Correct Answer: C Vote an answer

Question 13

A security risk has been discovered on the Service Provider MPLS core network during a network audit. Traceroute between the customer sites displays IP addresses of the Service Provider MPLS core. What should be done to hide the IP addresses of the Service Provider MPLS core from the customer traceroute utility?

A. Apply the no mpls ip propagate-ttl local command. B. Enable MPLS LDP session protection. C. Configure an LDP label allocation filter. D. Configure an access list to block traceroute traffic. E. Apply the no mpls ip propagate-ttl forward command.

Discussion 0

Correct Answer: E Vote an answer

Question 14

Refer to the exhibit.

RIP network 192.168.1.0/24 is redistributed in OSPF Area 1; both Area 1 and Area 2 are configured as NSSAs.
Which three statements describe the OSPF behavior in this scenario? (Choose three.)

A. Network 192.168.1.0/24 is advertised in a Type 5 LSA in Area 2. B. ABR between Area 0 and Area 2 converts network 192.168.1.0/24 to a Type 7 LSA. C. Network 192.168.1.0/24 is advertised in a Type 5 LSA in Area 0. D. Network 192.168.1.0/24 is advertised in a Type 7 LSA in Area 1. E. Network 192.168.1.0/24 is advertised in a Type 7 LSA in Area 0. F. Area 2 does not see the network 192.168.1.0/24 in its link-state database.

Discussion 0

Correct Answer: C,D,F Vote an answer

Question 15

Which three of these are types of Ethernet Virtual Connections (EVCs) in the MEF
concept? (Choose three)

A. rooted multipoint EVC (E-Tree) B. multipoint-to-multipoint EVC (E-LAN) C. point-to-multipoint EVC (E-Tree) D. hub spoke EVC (E-Tree) E. point-to-point EVC (E-Line)

Discussion 0

Correct Answer: A,B,E Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).