Cisco Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) - 350-401 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

What does the Cisco DNA Center Authentication API provide?

A. client health status B. access token to make calls to Cisco DNA Center C. list of VLAN names D. list of global issues that are logged in Cisco DNA Center

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 2

Where is radio resource management performed in a cisco SD-access wireless solution?

A. Cisco CMX B. wireless controller C. control plane node D. DNA Center

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 3

Which collection contains the resources to obtain a list of fabric nodes through the vManage API?

A. monitoring B. administration C. device inventory D. device management

Discussion 0

Correct Answer: C Vote an answer

Question 4

Which statement about an RSPAN session configuration is true?

A. A fitter mutt be configured for RSPAN Regions B. Only incoming traffic can be monitored C. A special VLAN type must be used as the RSPAN destination. D. Only one session can be configured at a time

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 5

What is the purpose of the LISP routing and addressing architecture?

A. It allows LISP to be applied as a network visualization overlay though encapsulation. B. It allows multiple Instances of a routing table to co-exist within the same router. C. It creates head-end replication used to deliver broadcast and multicast frames to the entire network. D. It creates two entries for each network node, one for Its identity and another for its location on the network.

Discussion 0

Correct Answer: D Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 6

Refer to the exhibit. A network operator is attempting to configure an IS-IS adjacency between two routers, but the adjacency cannot be established. To troubleshoot the problem, the operator collects this debugging output. Which interfaces are misconfigured on these routers?

A. The peer router interface is configured as point-as-point, and the R2 interface is configured as multipoint. B. The R2 interface is configured as point-to-point, and the peer router interface is configured as multipoint. C. The peer router interface is configured as Level 1 only, and the R2 interface is configured as Level 2 only D. The R2 interface is configured as Level 1 only, and the Peer router interface is configured as Level 2 only

Discussion 0

Correct Answer: D Vote an answer

Question 7

Which of the following multicast address ranges match the administratively scoped block?
(Choose two.)

A. 232.0.0.0 to 232.255.255.255 B. 239.0.0.0/8 C. 224.0.1.0/24 D. 224.0.0.0 to 224.0.0.255 E. 239.0.0.0 to 239.255.255.255

Discussion 0

Correct Answer: B,E Vote an answer

Question 8

In a campus network design, what are two benefits of using BFD for failure detection? (Choose two.)

A. BFD enables network peers to continue forwarding packets in the event of a restart. B. BFD speeds up routing convergence time. C. BFD is an efficient way to reduce memory and CPU usage. D. BFD provides fault tolerance by enabling multiple routers to appear as a single virtual router. E. BFD provides path failure detection in less than a second.

Discussion 0

Correct Answer: B,E Vote an answer

Question 9

Which component handles the orchestration plane of the Cisco SD-WAN?

A. vBond B. vEdge C. vSmart D. vManage

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 10

Refer to the exhibit. The trunk between SW2 and SW3 is not operational. Which action enables traffic for VLAN 200 to pass?

A. Configure vtp mode transparent on SW2 and SW3. B. Configure switchport mode dynamic desirable on SW2 and SW3 C. Configure no switch mode trunk on SW2 and SW3. D. Configure switchport nonegotiate SW2 and SW3

Discussion 0

Correct Answer: B Vote an answer

Question 11

What is the structure of a JSON web token?

A. three parts separated by dots version header and signature B. payload and signature C. header and payload D. three parts separated by dots header payload, and signature

Discussion 0

Correct Answer: D Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 12

Which QoS feature uses the IP Precedence bits in the ToS field of the IP packet header to partition traffic into different priority levels?

A. classification B. shaping C. marking D. policing

Discussion 0

Correct Answer: A Vote an answer

Question 13

Refer to the exhibit. An engineer is troubleshooting an issue with non-Wi-Fi interference on the 5- GHz band. The engineer has enabled Cisco CleanAir and set the appropriate traps, but the AP does not change the channel when it detects significant interference. Which action will resolve the issue?

A. Change the DCA Sensitivity option to High B. Enable the Event Driven Radio Resource Management option C. Enable the Avoid Persistent Non-WiFi interference option D. Disable the Avoid Foreign AP Interference option

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).