Cisco Supporting Cisco Routing and Switching Network Devices - 640-692 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

Which two of the following are component of WAN connection? (Choose two)

A. switch B. CSU/DSU C. Hub D. Bridge E. router

Discussion 0

Correct Answer: B,E Vote an answer

Question 2

Refer to the exhibit.

Which user-mode password has just been set?

A. SSH B. Console C. Auxiliary D. Telnet

Discussion 0

Correct Answer: D Vote an answer

Question 3

Refer to the exhibit.

What does the CD LED indicate on the voice WAN interface card?

A. An alarm condition B. A carrier has been detected C. Receive signal strength D. The interface is in loopback mode

Discussion 0

Correct Answer: B Vote an answer

Question 4

How does a Cisco switch respond if you boot it without a valid configuration in the NVRAM?

A. it enters user EXEC mode. B. it uses the running -configuration C. it enters setup mode. D. It prompts you to restore the startup configuration

Discussion 0

Correct Answer: B Vote an answer

Question 5

Which two of the following statements are true about a switch? (Choose two)

A. It is a data link layer device. B. It acts as an amplifier. C. It reads the destination MAC address to forward traffic out the appropriate port. D. It will forward the frame out all ports when it receives a broadcast from a host. E. It is a repeater.

Discussion 0

Correct Answer: A,C Vote an answer

Question 6

Which two of the following are features of NVRAM on a Cisco device? (Choose two)

A. Stores startup configuration B. Not erased when device is rebooted C. Stores running configuration D. Stores decompressed IOS software image E. Erased when device is rebooted F. Stores routing tables

Discussion 0

Correct Answer: A,B Vote an answer

Question 7

At the interface configuration prompt, which command returns you to the main configuration prompt?

A. exit B. quit C. end D. Ctrl-Z

Discussion 0

Correct Answer: A Vote an answer

Question 8

Which three of the following statements are true about a router? (Choose three)

A. It chooses the best route for your data to travel. B. It forwards broadcast frames. C. It interconnects multiple networks together. D. It manages and analyzes a company's database. E. It divides a network into separate broadcast domains.

Discussion 0

Correct Answer: A,C,E Vote an answer

Question 9

Which of the following best describes how to assign a static IP address to the Ethernet port on a computer?

A. Click Start> Run Enter cmd and click OK. Enter ip address XXX.XXX.XXX.XXX. B. From Network Connections, double-click Local Connection. Click Properties, click iPass Protocol (IEEE), click properties and select static IP. C. From Network Connections, double-click Local Area Connection. Click Protocol (TCP/IP). Click the properties, click the use the Following Address button, and then configure the IP information. D. From network Connections, click Create a New Connection and follow the network connection Wizard instructions.

Discussion 0

Correct Answer: C Vote an answer

Question 10

Which type of memory is necessary for a router to boot?

A. VRAM B. NVRAM C. PVDM D. DRAM

Discussion 0

Correct Answer: D Vote an answer