EMC Dell PowerEdge MX Modular Deploy 2023 - D-PEMX-DY-23 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

A technician is doing an initial MX7000 setup and wants to use KVM to configure the MM. KVM is not working.
What are the two causes of this issue?
(Select 2)

A. Mouse is not connected. B. DP-to-DVI and DP-to-HDMI adapters are not supported. C. The resolution set on MM is too high. D. MM is going through a reset.

Discussion 0

Correct Answer: B,D Vote an answer

Question 2

An administrator is configuring a fully populated MX5016s storage sled to be accessed by four MX740c compute sleds. Each compute sled has an H745P Jumbo PERC installed. The disks in the storage sled are evenly distributed across all compute sleds using a Drive-Assigned storage configuration.
What is the maximum number of disks that each compute sled can detect from the MX5016s?

A. 2 B. 1 C. 16 D. 4

Discussion 0

Correct Answer: C Vote an answer

Question 3

What automatically opens a support case with technical support and collects the PowerEdge MX system state information that is required for troubleshooting an issue, then sends it securely to Dell EMC?

A. SupportAssist Collections B. SupportAssist Enterprise C. OpenManage Essentials D. OpenManage Enterprise

Discussion 0

Correct Answer: B Vote an answer

Question 4

What are the typical ambient inlet temperature readings that ATMOS hardware and fans support?

A. 25°C (77°F), 30°C (86°F), and 35°C (95°F) B. 15°C (59°F), 20°C (68°F), and 25°C (77°F) C. 20°C (68°F), 25°C (77°F), and 30°C (86°F) D. 30 uplink configuration combination of the Top of the Rack Switch and the MX70(104°F)

Discussion 0

Correct Answer: D Vote an answer

Question 5

How can a hard reset be performed on iDRAC?

A. Using the OME-M Interface and selecting Virtual Reseat B. On the iDRAC web interface, select the Reset option C. Using the RACADM command --SystemReset -t 0 -f D. On the server, press and hold the ID LED button for 15 seconds

Discussion 0

Correct Answer: D Vote an answer

Question 6

What is a characteristic of MX7000 networking in Scalable Fabric Mode?

A. Layer 2 bridging is disabled be default and interfaces must join a bridge domain (VLAN) before being to forward frames. B. Enabled by default, all switch-specific OS10EE capabilities are available. C. All switch interfaces are assigned to VLAN 1 by default and are in the same Layer 2 bridge domain. D. Available on MX9116n FSE and MX7116n FEM but not on the MX5108n.

Discussion 0

Correct Answer: D Vote an answer

Question 7

After a main board replacement, the easy restore process was not successful. A system administrator is not able to launch the Virtual Console.
What is the cause of this issue?

A. Enterprise license is not installed. B. ActiveX is not installed. C. Java is not installed. D. KVM is not present.

Discussion 0

Correct Answer: A Vote an answer

Question 8

At the initial release of the MX7000 for a daisy-chained configuration in a multi-chassis management group (MCM)m what is the maximum number of member chassis allowed, not counting the lead chassis?

A. 20 B. 9 C. 10 D. 16

Discussion 0

Correct Answer: B Vote an answer