EMC Associate - Networking - DEA-5TT2 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

On which OSI layers do standard ACL filters operate?

A. 4 and 7 B. 2 and 3 C. 2 and 7 D. 3 and 4

Discussion 0

Correct Answer: D Vote an answer

Question 2

Which route type is added to the routing table by a routing protocol?

A. Default route B. Dynamic C. Directly connected D. Static

Discussion 0

Correct Answer: B Vote an answer

Question 3

Which IP address is in the Class B range?

A. 191.56.44.200 B. 192.15.48.130 C. 100.100.90.87 D. 126.16.20.48

Discussion 0

Correct Answer: A Vote an answer

Question 4

What accurately describes the comparison between stacking and VLT?

A. Both VLT and stacking allow devices to use different versions of firmware provided that the switch family/ series is the same. B. VLT allows for more physical devices to appear as one virtual device than stacking does. C. Stacked switches and VLT peers allow "single pane of glass" management by maintaining a single control plane. D. Stacked switches share a common control plane while VLT peers maintain their own control plane.

Discussion 0

Correct Answer: D Vote an answer

Question 5

What is the default route preference value for a Border Gateway Protocol (BGP) internal route?

A. 110 B. 200 C. 40 D. 253

Discussion 0

Correct Answer: B Vote an answer

Question 6

What accurately describes IPv6 addressing?

A. IPv6 uses broadcast addresses for neighbor discovery. B. IPv6 uses 128 hexadecimal numbers instead of the 32 hexadecimal numbers used by IPv4. C. IPv6 addresses are denoted by eight groups of four hexadecimal numbers. D. IPv6 is used to converse IP addresses and utilize private addresses.

Discussion 0

Correct Answer: C Vote an answer

Question 7

If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?

A. Multicast B. Unicast C. Anycast D. Broadcast

Discussion 0

Correct Answer: A Vote an answer