EMC Dell Networking Professional - DNDNS-200 FREE EXAM DUMPS QUESTIONS & ANSWERS
The exhibit shows an IGMPv2 multocast network where "Rn" are routers configured with PIM and OSPF runs between the routers.
Which two actions should the router(s) take with the multicast message forwaded to them from the switch connected to the user's desktop?
Which two actions should the router(s) take with the multicast message forwaded to them from the switch connected to the user's desktop?
Correct Answer: C
Vote an answer
A network engineer removes a new Dell Networking N-Series switch from the original shipping container and initially configures STP on the switch. While the engineer is working on another task, another individual modifies the VLAN 1 STP priority to 61440, and has saved to the startup configuration.
Which command should be issued to return the switch to the default STP priority value for VLAN 1?
Which command should be issued to return the switch to the default STP priority value for VLAN 1?
Correct Answer: C
Vote an answer
What is the correct syntax to configure an Out-of-Band interface on an N-Series switch?
Correct Answer: D
Vote an answer
Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).
Two Dell S-Series Switches are directly connected.
Which statement describes what will happen when a ping is sent from Dell-1 to Dell-2?
Which statement describes what will happen when a ping is sent from Dell-1 to Dell-2?
Correct Answer: D
Vote an answer
A network engineer is implementing MLAG using two N-Series switches, MLAG must be set up with 10 Gb ports and connecting to a single S-Series switch that will run 802.3ad to the MLAG Peers. The commands will be identical on the two N-Series switches. All ports on the N-Series switches are available to use. The VLAN that must be used is 10. The management interface on each N-Series switch has already been assigned an IP address.
Which set of commands should be used to meet the requirement for MLAG?
Which set of commands should be used to meet the requirement for MLAG?
Correct Answer: A
Vote an answer
Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).
Refer to the exhibits. A network engineer is troubleshooting an intermittent connectivity issue on a network.
The issue only occurs on VLANs 10 and 20.
Exhibit 1:
Exhibit 2:
Which configuration on the Z-Series is incorrect?
The issue only occurs on VLANs 10 and 20.
Exhibit 1:
Exhibit 2:
Which configuration on the Z-Series is incorrect?
Correct Answer: D
Vote an answer
The term "Forwarding Delay" has which default value related to 802.1D?
Correct Answer: A
Vote an answer
A network engineer is assigning any available switchport to a management VRF on an S-Series switch. The address to be used is 10.1.1.1, with a subnet mask of 255.255.255.0.
Which syntax should the network engineer use?
Which syntax should the network engineer use?
Correct Answer: D
Vote an answer
A customer has two locations that are six miles apart and connected by customer-owned dedicated fiber. The customer tells the deployment engineer that the two sites need to be connected by 10 Gb.
Which two requirements should the deployment engineer verify? (Choose two.)
Which two requirements should the deployment engineer verify? (Choose two.)
Correct Answer: A,F
Vote an answer
Refer to the exhibits of the S-Series switch.
A networking engineer is unable to pass traffic across interface port 13 and 43 for Dell1 and Dell2 S-Series switches, respectively.
Based on the exhibit, what is the problem with the configuration for the switches?
Correct Answer: B
Vote an answer