Fortinet NSE 6 - FortiNAC 7.2 - NSE6_FNC-7.2 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

View the command and output.

What is the state of database replication?

A. Primary to secondary database synchronization was successful. B. Secondary to primary synchronization failed. C. Primary to secondary synchronization failed. D. Secondary to primary synchronization was successful.

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 2

Which two of the following are required for endpoint compliance monitors? (Choose two.)

A. Logged on user B. Custom scan C. Security rule D. Persistent agent

Discussion 0

Correct Answer: B,D Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 3

What causes a host's state to change to "at risk"?

A. The logged on user is not found in the Active Directory. B. The host has failed an endpoint compliance policy or admin scan. C. The host has been administratively disabled. D. The host is not in the Registered Hosts group.

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 4

During an evaluation of state-based enforcement, an administrator discovers that ports that should not be under enforcement have been added to enforcement groups. In which view would the administrator be able to determine who added the ports to the groups?

A. The Alarms view B. The Event Management view C. The Admin Auditing view D. The Security Events view

Discussion 0

Correct Answer: C Vote an answer

Question 5

When FortiNAC is managing VPN clients connecting through FortiGate. why must the clients run a FortiNAC agent?

A. To collect user authentication details B. To collect the client IP address and MAC address C. To meet the client security profile rule for scanning connecting clients D. To transparently update the client IP address upon successful authentication

Discussion 0

Correct Answer: C Vote an answer

Question 6

When configuring isolation networks in the configuration wizard, why does a Layer 3 network type allow for more than one DHCP scope for each isolation network type?

A. Any scopes beyond the first scope are used if the Initial scope runs out of IP addresses. B. The Layer 3 network type allows for one scope for each possible host status. C. There can be more than one isolation network of each type. D. Configuring more than one DHCP scope allows for DHCP server redundancy.

Discussion 0

Correct Answer: C Vote an answer