Fortinet NSE 7 - Secure Networking 7.6 Architect - NSE7_FSN_AR-7.6 FREE EXAM DUMPS QUESTIONS & ANSWERS

A. DNS cannot resolve the workstation name. B. The workstation remote registry service is not running. C. Traffic to ports 139 and 445 is blocked. D. The workstation has come out of hibernate mode.

A. The packet was dropped because there is no route to the source. B. The packet was dropped because it is not allowed by any firewall policy. C. The packet was dropped because the requested service is not enabled on FortiGate D. The packet was dropped because the trusted host list is misconfigured

A. Policy routes, ISDB routes, SD-WAN rules, static routes. B. SD-WAN rules, ISDB routes, policy routes, BGP routes. C. SD-WAN rules, policy routes, static routes, ISDB routes. D. Policy routes, SD-WAN rules, Internet Service Database (ISDB) routes, BGP routes.

A. BGP template B. IPsec tunnel template C. Static route template D. Rules template E. CLI template

A. The local router has not received an OPEN message from the neighbor. B. The neighbor router has become unreachable, which is evident by the low ratio of messages received to messages sent. C. There is no active route to the BGP neighbor. D. The local router has not received a SYN/ACK packet from the neighbor.

A. The port1 default static route will be injected into the FIB. B. The port2 default static route will be injected into the forwarding information base (FIB). C. Both default static routes shown in the output will be injected into the FIB. D. Neither of the routes shown in the output will be injected into the FIB.

A. set auto-discovery-crossover enable and set enforce-multihop enable B. set auto-discovery-sender enable and set network-id x C. set auto-discovery-receiver enable and set remote-ip x D. set auto-discovery-forwarder enable and set remote-as x

A. Some of them display output only after you run the diagnose debug console enable command. B. Some of them display statistics and configuration information about a feature or process. C. Some of them can be used to restart an application. D. Some of them display real-time application debugs.

A. Set multipath to enable. B. Set route-overlap to either use-new or use-old. C. Set net-device to ecmp. D. Set route-overlap to allow.

A. You must authorize the downstream FortiGate on the root FortiGate. B. You must configure FortiGate in transparent mode. C. You must enable FortiTelemetry on the receiving interlace of the upstream FortiGate. D. You must ensure that TCP port 8013 is not blocked along the way. E. You must ensure that the port for Neighbor Discovery has been changed.

A. FortiGate has OSPF ECMP enabled. B. FortiGate injects external routing information. C. FortiGate is connected to multiple areas. D. FortiGate is a backup designated router.

A. There is no autonomous system border router (ASBR) in the network, B. The local router is located in a stub area C. The peer of the local router is using a prefix-list-out. configuration to prevent all type 5 LSAs to be advertised. D. IP protocol 89 is blocked between the local router and its peer.

A. An SD-WAN rule B. An ISDB route C. A regular policy route, which is associated with an active static route in the FIB D. A regular policy route

A. At least one protocol port under Protocol Options has been mapped to Any. B. SSL deep inspection is not configured. C. FortiGate does not have enough free memory to perform proxy-based inspections. D. The FTP protocol has not yet been mapped to port 211 under Protocol Options.