HP Network Infrastructure AIS 2011 - HP2-Z18 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

What is the effect of the following command issued at the CLI of an HP E3500-24G yl switch?
E3500-24G# show logging 24

A. The CLI displays all events in the system log that include the string "24". B. The CLI displays all events logged in the previous 24 hours. C. The CLI displays all events associated with all ports. D. The CLI displays all events associated with port 24.

Discussion 0

Correct Answer: D Vote an answer

Question 2

You have enabled RtPv2 with the following command at the CLI of an HP E3500 yI switch:
E3500(config)# router rip
E3500(rip)#
However, the switch does not locate any RIP peers. How can you explain this result?

A. You have not set the switch's RIP pri onty peeri ng i n the RIP context B. You have not enabled RIP for every VLAN where the switch is expected to locate RIP peers. C. Your nearest RIP peer is more than 15 hops away. D. You have not configured a static route to the nearest RIP peer.

Discussion 0

Correct Answer: B Vote an answer

Question 3

You make configuration changes to the running configuration of your HP E3500 yI switch. Which command saves these changes to your startup configuration?

A. write memory B. copy running-config startup-config C. save running-config D. write config

Discussion 0

Correct Answer: A Vote an answer

Question 4

What is the VLAN status of the ports on an HP A-Series switch at factory default settings?

A. All ports are access ports using VLAN 1 as their default VLAN. B. VLANs are unassigned until a port mode is defined. C. All ports are in a learning state waiting for VLAN assignment through GVRP. D. All ports are trunk ports using VLAN 1 as their default VLAN

Discussion 0

Correct Answer: A Vote an answer

Question 5

DRAG DROP
Place each type of AP next to its description.

Discussion 0

Correct Answer:

Explanation:

Question 6

A network administrator has successfully installed the HP ProCurve Manager remote client on his workstation. He can ping the PCM+ server, but he is denied access when trying to connect to the PCM+ server. The IP address of his workstation is 172.16.17.100/16. The IP address of the PCM+ server is 172.15.15.100/16.
How can you resolve this problem?

A. Add a route to the 17.15.0.0/16 network on the switch connected to the client workstation. B. Add the administrator's user ID to the User Profiles in PCM+. C. Add the IP address of the administrator's workstation to the Authorized Managers list on the switch that the PCM+ server uses as a seed device. D. Add 172.16.0.0/16 to the Managed Subnets list in the PCM+ discovery setup window E. Add the IP address of the administrator's workstation to the access.txt file on the PCM+ server.

Discussion 0

Correct Answer: D Vote an answer

Question 7

You must configure port GigabitEthernet 1/0/1 on an HP A-Senes switch so that it can support policy-based VLANs and port-based VLANs Which type of port is required to support this configuration?

A. tagged B. access C. trunk D. hybrid

Discussion 0

Correct Answer: D Vote an answer

Question 8

What are the advantages of deploying 802.11n wireless technology instead of 802.11a technology? (Select two.)

A. support for centralized WLAN architecture B. 5Ghz operating frequency C. backward compatibility with 802.11b D. more powerful encryption options E. higher transmission rates

Discussion 0

Correct Answer: B,E Vote an answer

Question 9

A Virtual Service Community (VSC) is similar to which non-HP mobility solution?

A. wireless bridging B. WPA C. WDS D. SSID

Discussion 0

Correct Answer: D Vote an answer

Question 10

Which HP E-Series switch models display the following prompt in the interface configuration context? (Select two)
HP Switch (eth-A24)#

A. E6600-24G B. E5412-96GZI C. E350CM8G-POEyI D. E8212zl E. E2910-24Gal

Discussion 0

Correct Answer: B,D Vote an answer