HP Fast Track - Applying HPE FlexNetwork Fundamentals - HP2-Z37 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

Refer to the exhibit.

The network administrator wants to permit management access to Switch 2 through Switch 20 for HPIntelligent Management Center (IMC).The 10 1.10.0/24 subnet only has 10 free addresses.What should the administrator do to enable IMC to manage Switch 2 through Switch 20?

A. Configure the same IP address in 10.1.10.0/24 on VLAN 10 on all of the switches. B. Configure a default route on all of the switches through 10.1.10.1. C. Configure a default route on all of the switches through 10.1.2 1. D. Configure the same IP helper address, 10.1.2.1, on VLAN 2 on all of the switches

Discussion 0

Correct Answer: D Vote an answer

Question 2

A network administrator has copied new software to the secondary slot on an HP Provision switch. The administrator wants to schedule a boot to the new software in two hours. What should the administrator do to accomplish this?

A. Use the boot set-default command to configure the switch to boot to the secondary software. Then use the boot system flash command to schedule the reboot. B. Use theboot set-default command to configure the switch to boot to the secondary software. Then use the reload command to schedule the reboot C. Use the boot system flash command to configure the switch to boot to the secondary software. Then use the same command again to schedule the reboot. D. Use the boot system flash command to configure the switch to boot to the secondary software. Then use the reload command to schedule the reboot.

Discussion 0

Correct Answer: A Vote an answer

Question 3

A network administrator is setting up Rapid Spanning Tree Protocol (RSTP) on several HP Provision switches. Currently, the switches are using the default spanning tree settings. How can the administrator ensure that Switch-1 becomes root?

A. Set bridge priority 15 on Switch-1. B. Set spanning tree costs of 0 of all the Switch-1 ports. C. Set bridge priority 0 on Switch-1. D. Set spanning tree costs of 15 of all the Switch-1 ports.

Discussion 0

Correct Answer: C Vote an answer

Question 4

Refer to the exhibit.

A link aggregation is already set up on an HP Comware switch, as shown in the exhibit. The links in this link aggregation connect to interface 1 and 2 on an HP ProVision switch. How should the network administrator configure the link aggregation on the HP Provision switch?

A. Add interface 1 and 2 to a static bridge aggregation interface. B. Add interface 1 and 2 to a trunk, and use the default option. C. Add interface 1 and 2 to a trunk and use the lacp option. D. Add interface 1 and 2 to a dynamic bridge aggregation interface.

Discussion 0

Correct Answer: D Vote an answer

Question 5

Refer to the exhibit.

The exhibit shows the IP routing table for an HP Provision switch. The network administrator then enters these commands:

What is the result of this configuration?

A. All four routes are added to the routing table, but are never used. B. The switch only adds the last static route entry to the routing table. C. The switch only adds the last two static route entries to the routing table. D. The switch load shares connections across the four static next hops.

Discussion 0

Correct Answer: A Vote an answer