HP Aruba Certified Switching Expert Written - HPE6-A69 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

Which functionalities of ClearPass can be added in a wired network that implements dynamic segmentation?
(Select two.)

A. Multi Factor Authentication B. Profiling C. Dynamic VLANs D. Fingerprinting E. Downloadable user Roles

Discussion 0

Correct Answer: A,C Vote an answer

Question 2

Refer to the exhibit.

You want to protect the aggregation layer if the VSXISL falls. Where should you place a VSX keepalive link?

A. On VSX LAG 101 B. On VSX LAG 1 C. On the OOBM ports of both aggregation switches D. On a dedicated link created using port 1'1/48 of each aggregation switch

Discussion 0

Correct Answer: C Vote an answer

Question 3

A client connected to Aruba CX 6300 on Port vt/2 Is having issues connecting to a remote destination 10 100
10 62 port 443. How should you get session-specific diagnostic information about this connection?

A. Run tcpdump -interface "1/1/2" host 10.100 10.62 to capture the session B. Use diag utilities tcpdump desttnation-ip 10 10010.62 to capture the session C. Use diag utilities tcpdump destination-prefix 10 100 10.62/32 to capture the session D. Enter diag-mode and execute tcpdump ip.addr==10.100.10.62.

Discussion 0

Correct Answer: C Vote an answer

Question 4

When planning a new wired network solution for an organization, mere are technical goals that must be achieved to support the organization objectives and their applications and services.
Which options are valid technical goals? (Select two.)

A. Transform the process of acquisition of a new network solution from a CAPEX to an OPEX model B. Replace hardware that is reaching end of support with a technology refresh. C. improve the network throughput D. Accelerate the ordering process of new network hardware. E. Reduce the cost of wiring.

Discussion 0

Correct Answer: A,D Vote an answer

Question 5

Refer to the exhibit.

Aruba CX 6300 switch has routes in three different VRFs as per the example above. The user needs to leak routes between VRF Secure and VRF Dev. and also between VRF default and VRF Dev The customer Is not able to establish routing between directly connected networks 10.100.50.0/24 and
10.102.26.0/24 Which statement is true regarding the routing troubleshooting?

A. Route leaking between default and non-default VRFs is supported with Aruba CX 8400. B. Multi-protocol BGP routing needs to be defined for route leaking C. Route Distinguisher needs to be set to 1 for default VRF. D. Route leaking is supported between non-default VRFs only

Discussion 0

Correct Answer: B Vote an answer

Question 6

Which statement is true about NAE scripts'?

A. The Health Monitor is the only script installed on the system by default. B. The System Resource Monitor is the only script Installed on the system by default. C. The System Resource Monitor and Health Monitor a/e the only scripts installed on the system by default D. No script is installed on the system by default.

Discussion 0

Correct Answer: B Vote an answer