HP Aruba Certified Campus Access Associate - HPE6-A85 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

When using the OSFP dynamic routing protocol on an AOS-CX switch, what must match on the neighboring devices to exchange routes?

A. router-id B. loopback configuration C. OSPF passive configuration D. OSPF area

Discussion 0

Correct Answer: D Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 2

What is used by network devices to send error and operational information related to IP communications?

A. Cyclic Redundancy Check (CRC) B. Frame Check Sequence (FCS) C. Internet Control Message Protocol (ICMP) D. User Datagram Protocol (UDP)

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 3

A client connects to an Aruba AP in tunnel mode and is assigned to a VLAN based on the client's MAC address.
Which client VLAN assignment was configured?

A. Mixed B. Dynamic C. Static D. Native VLAN

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 4

You have physical access to an Aruba CX-Switch with unknown/lost credentials. What are the possible steps to rebuild the credentials? (Select two.)

A. Press and hold the clear button. Then, press the reset button for 2 seconds and release both buttons. B. Call Aruba support for a one-time password. C. Press and hold the clear button. Then, power-cycle the switch. D. Connect the switch via the console. Then, power cycle the switch. E. Use boot profile 0.

Discussion 0

Correct Answer: C,E Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 5

What is an advantage of using Layer 2 MAC authentication?

A. MAC allow lists are easily maintained over time B. No setup is required on the client C. MAC identifiers are hard to spoof D. it matches user names to MAC address

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 6

Review the configuration below. Why would you configure OSPF to use the IP address
10.1.200.1 as the router ID?

A. The IP address associated with the loopback interface is routable and prevents loops B. The loopback interface state Is independent of any physical interface and reduces routing updates. C. The loopback interface state is dependent on the management interface state and reduces routing updates. D. The IP address associated with the loopback interface is non-routable and prevents loops

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 7

Where can you set the client's broadcast domain when configuring an ArubaOS firewall role?

A. Bandwidth Controls B. WLAN Settings C. Role-based VLAN override D. Access Control Rules

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 8

A customer with 1,860 employees has just implemented user and device certificates via a company-wide Group Based Policy (GPO). When authenticating to the network, which EAP method chains user and machine authentication in one RADIUS session?

A. EAP-TEAP B. EAP-TTLS C. PEAP D. EAP-TLS

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).