Huawei HCIP-Carrier IP V2.0 - H31-124_v2.0 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

LDP uses Initialization message to negotiate LDP parameters with the peer.

A. True B. False

Discussion 0

Correct Answer: A Vote an answer

Question 2

What are the main features of the SDN controller?

A. Upgrading Routing Protocols B. Centralized networking C. Open interface D. Separating the Data Plane and Control Plane

Discussion 0

Correct Answer: B,C,D Vote an answer

Question 3

Which of the following statements is correct regarding virtual router?

A. If multiple routers associate to the same virtual router, they must be configured with the same virtual router ID and at feast one virtual IP address. B. If multiple routers are configured with the same virtual router ID.they all associate to the same virtual router. C. If multiple routers associate to the same virtual router, they must be configured with the same virtual router ID and virtual IP address. D. If multiple routers are configured with the same virtual IP address, they all associate to the same virtual router.

Discussion 0

Correct Answer: C Vote an answer

Question 4

BGP Is an exterior gateway protocol which runs among ASs. It focuses on routes control and selection of optimal routes rather than discovery and calculation of routes.

A. True B. False

Discussion 0

Correct Answer: A Vote an answer

Question 5

Which of the statements about BGP UPDATE message are correct?

A. One UPDATE message can include multiple unreachable routes. B. BGP uses Update message to implement routing information updating. C. One UPDATE message can advertise multiple routes at one time, but the path attributes must be the same. D. One UPDATE message can advertise multiple routes at one time, and the path attributes can be different.

Discussion 0

Correct Answer: A,B,C Vote an answer

Question 6

Which of the following are necessary for ISIS to support MPLS TE?

A. Use command "traffic-eng" to enable ISIS-TE in IS-IS view. B. Configuring wide-metric support in ISIS view. C. Use command "mpls-te enable" to enable MPLS TE in ISIS view. D. Use command "opaque-capability enable" to enable opaque capability in ISIS view.

Discussion 0

Correct Answer: A,B Vote an answer