Huawei Certified Network Associate-GSM RNP&RNO - H35-510-ENU FREE EXAM DUMPS QUESTIONS & ANSWERS

The 1800M GSM bandwidth allocated by the country to China Unicom is?

In the handover process in the BSC, after the handover is completed, the BSC reports the ___ message to the MSC.

Which of the following numbers are used to identify the base station?

Triggering "TA handover" requires the serving cell to be higher than the TA threshold, and the target cell is queued relatively high, but it is not required to be ranked in front of the serving cell.

The Frame number encoding in the same paging is small, which can speed up the paging response time; the disadvantage is that the battery consumption of the MS is fast, and the number of paging subchannels is small.

The success rate of the BSC handover in a cell is relatively low, and the number of cell handover attempts between the BSCs in the voice system and the number of cell handover attempts between the BSCs are almost equal. What might be the reason for the failure of the BSC handover in this cell?

"four-diversity reception mode" by inputting four signals received from different antennas in different polarization directions to the same carrier signal, higher uplink diversity gain than the traditional two receive diversity modes can be obtained. Thereby enhancing the uplink coverage effect, belonging to the coverage enhancement technology. Huawei BTS3900 and DBS3900 support four-diversity reception mode.

What are the interfaces between MS, BTS, BSC, TC and MSC?

GSM uses which multiple access multiplexing?

When the network characteristic bit adjustment is performed according to the switching 16-bit sorting rule, only the load switching switch is turned on, and the load adjustment bit therein functions.

Link net loss includes maximum path loss and gain and loss of the antenna system, where the maximum path loss refers to the calculation of gain and loss from the transmitter antenna to the receiver antenna, which has nothing to do with the transmitting and receiving equipment.

Under the condition of Any carrier to interference ratio, the data transfer rate with using MCS9 channel coding scheme is higher than the one with using MCS5 channel coding scheme.

According to the adjustment experience of multiple networks, improving the overall transmit power is beneficial to the road test, and reducing the overall transmit power improves the overall network KPI (receive quality, call drop rate, etc.). When adjusting parameters, you need to make trade-offs based on the focus of the network assessment.