IBM Virtualization Technical Support for IBM i -v1 - 000-121 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

What minimum hardware and software levels are required to host IBM i on other IBM i partitions?

A. POWER5+ or newer, IBM i 6.1 or newer B. POWER6 or newer, IBM i 6.1 or newer C. POWER5+ or newer, IBM i 5.4 or newer D. POWER6+ or newer, IBM i 7.1 or newer

Discussion 0

Correct Answer: B Vote an answer

Question 2

While creating a new partition and choosing appropriate I/O resources, nothing appears on the Tagged I/O screen to be selected as a "Load Source." Which of the following could cause this to happen?

A. Resources are only marked as Desired, not as Required. B. The CEO is not in "standby' mode. C. Supported resources for a load source adapter have not been included in the profile. D. The disk attached to the controller is not powered-on.

Discussion 0

Correct Answer: A Vote an answer

Question 3

What is the purpose of Tagged I/O in a partition profile?

A. To specifywhich hardware elements are available to be shared using NPIV B. To configure vLANs on Host Ethernet Adapters C. To specify critical hardware elements, without which the profile cannot be loaded or run D. To allow the HMCto identifythe load source disk unit

Discussion 0

Correct Answer: C Vote an answer

Question 4

A customer is moving two AIX partitions from an older System p server to a new POWER7 server running IBM i. One partition requires 1.0 processor the other .5. How many AIX licenses are required?

A. 1.5 B. 2 C. 1 D. 0

Discussion 0

Correct Answer: B Vote an answer

Question 5

A new IBM i client partition has been created. Storage for the client partition is being provided by a hosting IBM i partition. All steps regarding linking of network servers to storage spaces have been performed. When varying on the Network Server Description (NWSD) from the hosting partition, nothing occurs with the new client partition.
What is the most likely reason?

A. The processor settings are "capped" rather than "uncapped." B. Power control has not been properly configured. C. Shared memory has not been enabled in the hosting partition. D. I_BASE_01 media is not in any accessible optical or virtual optical drive.

Discussion 0

Correct Answer: B Vote an answer

Question 6

An administrator is planning to update a POWER blade server managed with Integrated Virtualization Manager (IVM) from version 1.5 to version 2.2
What should the administrator take into consideration?

A. The administrator should use the Advanced Management Module (AMM) interface to specify the location of the migration DV B. All client partitions should be shut down before starting the migration to avoid data corruption. C. The partition profile data will need to be saved before the migration and restored once the migration is complete. D. The migration can only occur using a Serial Over LAN (SOL) console.

Discussion 0

Correct Answer: B Vote an answer

Question 7

Which PowerVM feature can be used to enable an IBM i partition to IPL from an iBase_01 image?

A. Virtual optical through Network Server Description B. VirtualMedia Repository C. Remote Image Catalog over NES D. Remote Image Catalog through QFileSvr.400

Discussion 0

Correct Answer: B Vote an answer