ISQI ISTQB Certified Tester Foundation Level - CTFL_001 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

When an organization considers the use of testing tools, they should:

A. Allow the developers to select the testing tools because tools are technical and developers have the appropriate skills to advise on test tool selection and configuration. B. Perform analysis of the test process and then assess whether it can be supported through the introduction of tool support. C. Use a tool in order to help define a good test process because the tool will force process repeatability and therefore enforce good test process. D. Always start by bringing in automated test execution tools as these tools have the greatest return on investment and therefore should be introduced first.

Discussion 0

Correct Answer: B Vote an answer

Question 2

Incidents would not be raised against

A. Improvements suggested by users B. Test cases C. Requirements D. Documentation

Discussion 0

Correct Answer: A Vote an answer

Question 3

Which of the following risks represents the highest level of risk to the project?

A. Likelihood of failure = 10%, potential cost of impact = $500,000. B. Likelihood of failure = 20%, potential cost of impact = $150,000. C. Likelihood of failure = 5%, potential cost of impact = $500,000. D. Likelihood of failure = 1%, potential cost of impact = $1m.

Discussion 0

Correct Answer: A Vote an answer

Question 4

Which of the following statements BEST describes the difference between testing and debugging?

A. Testing pinpoints (identifies the source of) the defects. Debugging analyzes the faults and proposes prevention activities. B. Dynamic testing shows failures caused by defects. Debugging finds, analyzes, and removes the causes of failures in the software. C. Dynamic testing prevents causes of failures. Debugging removes the failures. D. Testing removes faults. Debugging identifies the causes of failures.

Discussion 0

Correct Answer: B Vote an answer

Question 5

Which of the following metrics could be used to monitor progress along with test preparation and execution? [K1]

A. The number of testers used for test execution so far B. The total number of tests planned C. The total number of requirements to be tested D. The failure rate in testing already completed

Discussion 0

Correct Answer: D Vote an answer

Question 6

Testing effort can depend on a number of factors, which one of following is MOST likely to impact the amount of effort required?

A. The planned use of a project management tool to schedule tasks B. The predicted number of defects and the amount of rework required C. The ratio of developers to testers in the project team D. The responsibilities for testers and developers being clearly defined

Discussion 0

Correct Answer: A Vote an answer

Question 7

A test assessment has been carried out using the selected model as a reference framework. A number of recommendations have been identified and you are asked to prioritize them. Based on your knowledge of the project, you are expecting severe resistance to change. Which of the following would be the most important selection criterion for defining the priority of the recommendations? 2 credits

A. Low costs actions first B. Synchronized with the overall long-term organizational strategy C. Most visible to stakeholders D. Defined according to the maturity model used

Discussion 0

Correct Answer: C Vote an answer

Question 8

Debugging and Testing are key activities in the software development lifecycle.
Which of the following are 'Debugging' activities?
a) Identifying, a failure
b) Locating the cause of failure
c) Fixing the defect
d) Checking the fix has resolved the failure

A. a & b B. b & c C. c & d D. a & d

Discussion 0

Correct Answer: B Vote an answer

Question 9

Which of the following principles should be followed when introducing a test tool into an organization?
(i) Assessing organizational maturity to establish whether a tool will provide expected benefits.
(ii) Requiring a quick payback on the initial investment.
(iii) Including a requirement for the tool to be easy to use without having to train unskilled testers.
(iv) Identifying and agreeing requirements before evaluating test tools.

A. (ii) and (iii) B. (i) and (iv) C. (iii) and (iv) D. (i) and (ii)

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 10

For which of the following activities in the fundamental test process would an incident management tool be most useful?

A. Test implementation and execution B. Evaluating exit criteria and reporting C. Test analysis and design D. Test planning and control

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).