Juniper networks Certified internet specialist.e(jncis-e) - JN0-130 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

In a Bridged 1483 network, which set of commands is used to configure an ATM sub-interface?

A. interfaceatm 6/0.33 atmpvc 33 0 33 aal5snap encapsulationbridge1483 ipdescription Company-XYZ ipaddress unnumbered loopback0 B. interfaceatm 6/0.33 atmpvc 33 0 33 aal5snap ipdescription Company-XYZ encapsulationbridge1483 ipaddress unnumbered loopback0 C. interfaceatm 6/0.33 atmpvc 33 0 33 aal5snap ipdescription Company-XYZ encapsulationbridge1483 ipunnumbered loopback0 D. interfaceatm 6/0.33 atmpvc 33 0 33 aal5snap encapsulationbridge1483 ipdescription Company-XYZ ipunnumbered loopback0

Discussion 0

Correct Answer: D Vote an answer

Question 2

Which configuration command assigns a host route to the CPE workstation address of
192.168.10.1 in a Bridged 1483 network?

A. ip route 192.168.10.1 255.255.255.255 atm 6/2.1 B. add route 192.168.10.1 255.255.255.252atm 6/2.1 C. add route 192.168.10.1 255.255.255.255atm 6/2.1 D. ip route 192.168.10.1 255.255.255.252 atm 6/2.1

Discussion 0

Correct Answer: A Vote an answer

Question 3

A Bridged 1483 network is grouping all DSL users into a single logical subnet. Which configuration command prevents the end users from directly communicating with each other?

A. noip arp B. restrictip arp C. noip proxy-arp D. restrictip proxy-arp

Discussion 0

Correct Answer: C Vote an answer

Question 4

You would like to configure a Frame Relay interface with the following characteristics: ?
Serial interface 4/0:3/1 ?
192.168.9.2/24 ? PVC - 16 ? DCE
Which set of configuration commands accurately completes this task?

A. interface serial 4/0:3/1 enableframe-relay ietf interfaceserial 4/0:3/1.1 frame-relayinterface-dlci 16 ietf ipaddress 192.168.9.2 255.255.255.0 B. interface serial 4/0:3/1 encapsulationframe-relay ietf frame-relayintf-type dce interfaceserial 4/0:3/1.1 frame-relayinterface-dlci 16 ietf ipaddress 192.168.9.2 255.255.255.0 C. interface serial 4/0:3/1 encapsulationframe-relay ietf frame-relayintf-type dce frame-relayinterface-dlci 16 ietf interfaceserial 4/0:3/1.1 ipaddress 192.168.9.2 255.255.255.0 D. interface serial 4/0:3/1 encapsulationframe-relay ietf frame-relayintf-type dce frame-relayinterface-dlci 16 ietf ipaddress 192.168.9.2 255.255.255.0 interfaceserial 4/0:3/1.1

Discussion 0

Correct Answer: B Vote an answer

Question 5

What is true about a Bypass Tunnel in MPLS Fast Reroute?

A. Only configured on the egress router. B. Only configured on the ingress router. C. Must intersect the primary LSP at two locations. D. Is pre-signalled to reduce packet loss.

Discussion 0

Correct Answer: C Vote an answer

Question 6

Which control expression must be the last line in all macros?

A. <#endtmpl #> B. <# end #> C. <# terminate #> D. <# finish #>

Discussion 0

Correct Answer: A Vote an answer

Question 7

Which two statements are true about precedence values in policy? (Choose two.)

A. 100 is the default precedence. B. 1 is the default precedence. C. A lower number is preferred. D. A higher number is preferred.

Discussion 0

Correct Answer: A,C Vote an answer