Juniper Security, Professional (JNCIP-SEC) - JN0-633 FREE EXAM DUMPS QUESTIONS & ANSWERS

Click the Exhibit button. -- Exhibit-

-- Exhibit -
Host traffic is traversing through an IPsec tunnel. Users are complaining of intermittent issues with their connection.
Referring to the exhibit, what is the problem?

You want to route traffic between two newly created virtual routers without the use of logical systems using the configuration options on the SRX5800.
Which two methods of forwarding, between virtual routers, would you recommend? (Choose two.)

Click the Exhibit button.
user@host> monitor traffic interface ge-0/0/3
verbose output suppressed, use <detail> or <extensive> for full protocol decode
Address resolution is ON. Use <no-resolve> to avoid any reverse lookup delay.
Address resolution timeout is 4s.
Listening on ge-0/0/3, capture size 96 bytes
Reverse lookup for 172.168.3.254 failed (check DNS reachability). Other reverse lookup failures will not be reported.
Use <no-resolve> to avoid reverse lockups on IP addresses.
19:24:16.320907 In arp who-has 172.168.3.254 tell 172.168.3.1 19.24:17.322751 In arp who has 172.168.3.254 tell 172.168.3.1 19.24:18.328895 In arp who-has 172.168.3.254 tell
172.168.3.1
19.24:18.332956 In arn who has 172.168.3.254 tell 172.168.3.1
A new server has been set up in your environment. The administrator suspects that the firewall is blocking the traffic from the new server. Previously existing servers in the VLAN are working correctly. After reviewing the logs, you do not see any traffic for the new server.
Referring to the exhibit, what is the cause of the problem?

You are asked to change the configuration of your company's SRX device so that you can block nested traffic from certain Web sites, but the main pages of these Web sites must remain available to users.Which two methods will accomplish this goal? (Choose two.)

You are working as a security administrator and must configure a solution to protect against distributed botnet attacks on your company's central SRX cluster.
How would you accomplish this goal?

You are asked to implement a point-to-multipoint hub-and-spoke topology in a mixed vendor environment. The hub device is running the Junos OS and the spoke devices are different vendor devices.Regarding this scenario, which statement is correct?

For an SRX chassis cluster in transparent mode, which action occurs to signal a high availability failover to neighboring switches?

You are troubleshooting an SRX240 acting as a NAT translator for transit traffic. Traffic is dropping at the SRX240 in your network.Which three tools would you use to troubleshoot the issue? (Choose three.)

Somebody has inadvertently configured several security policies with application firewall rule sets on an SRX device. These security policies are now dropping traffic that should be allowed.You must find and remove the application firewall rule sets that are associated with these policies.Which two commands allow you to view these associations? (Choose two.)

Click the Exhibit button. -- Exhibit-

-- Exhibit -
You receive complaints from users that their Web browsing sessions keep dropping prematurely. Upon investigation, you find that the IDP policy shown in the exhibit is detecting the users' sessions as HTTP:WIN-CMD:WIN-CMD-EXE attacks, even though their sessions are not actual attacks. You must allow these sessions but still inspect for all other relevant attacks.
How would you configure your SRX device to meet this goal?

Click the Exhibit button. -- Exhibit-

-- Exhibit -Referring to the exhibit, AppTrack is only logging the session closure messages for sessions that last 1 to 3 minutes.
What is causing this behavior?

Click the Exhibit button.
IPv6 to IPv4 addresses are not being translated as shown in the exhibit.
Which two configurations would resolve the problem? (Choose two.)

You want to implement a hub-and-spoke VPN topology using a single logical interface on the hub.Which st0 interface configuration is correct for the hub device?