NACE Coating Inspector Level 1 - NACE-CIP1-001 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

ISO SA 3 is directly equivalent to:

A. NACE No. 2/SSPC SP 10 B. None of the above C. NACE No. 3/SSPC SP 6 D. NACE No. 1/SSPC SP 5

Discussion 0

Correct Answer: B Vote an answer

Question 2

Which one of the following documents is the best source for coating technical data:

A. Specification B. Application Guidelines C. Technical Data Sheet D. Safety Data Sheet;

Discussion 0

Correct Answer: C Vote an answer

Question 3

NACE Level 1 Inspectors have been trained to perform:

A. All types of inspection B. Visual inspection and Non-destructive testing C. Visual inspection, Non-Destructive and Destructive testing D. Visual inspection only

Discussion 0

Correct Answer: B Vote an answer

Question 4

You are the NACE Inspector on a job where ISO ST 3 has been specified. The Contractor normally works to SSPC standards and been referencing SSPC SP 3.
Could this have any impact on the final surface preparation appearance?

A. No, because there is no real difference in the standards B. It depends on which power tool the Contractor selects C. It depends on which hand tool the Contractor selects D. Yes, because the 'two standards are not equivalent

Discussion 0

Correct Answer: A Vote an answer

Question 5

What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) area?

A. 100% of the specified maximum thickness B. 90% of the specified maximum thickness C. 80% of the specified minimum thickness D. 70% of the specified maximum thickness

Discussion 0

Correct Answer: C Vote an answer

Question 6

You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
Your FIRST preferred course of action is to:

A. Document the problem and advise the Contractor B. Break the blisters to see what's inside C. Document the problem and advise the Contractor and Owner's representative D. Extract any liquid that may be inside the blister and send it to the lab for further analysis

Discussion 0

Correct Answer: C Vote an answer

Question 7

If the specifier does not identify a restriction level in accordance with SSPC PA 2, the default restriction level is:

A. Level 4 B. Level 1 C. Level 3 D. Level 2

Discussion 0

Correct Answer: C Vote an answer

Question 8

Removal of surface contaminants is done by:

A. Waterjetting B. A combination of methods C. Scarifying D. Abrasive blasting

Discussion 0

Correct Answer: B Vote an answer

Question 9

Checking is

A. a very small hole in a coating caused when air or solvent is trapped in porous film and then escapes. B. a fine crack in the surface of a coating that rarely reaches the substrate C. an exposed area of the substrate or previous coat material, caused by poor application technique. D. surface breaks in the film that often result from grease or oil contamination and revel the substrate.

Discussion 0

Correct Answer: B Vote an answer

Question 10

A magnetic pull-off type gauge is a good choice when:

A. When working on non-ferrous metals B. Performing an adhesion test C. When an intrinsically safe tool is required D. Accuracy is not required

Discussion 0

Correct Answer: C Vote an answer