Network Appliance NetApp Certified Support Engineer ONTAP Specialist - NS0-593 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

Your customer has mounted an NFS SVM from a Linux client unci performance is very poor. The customer is certain that they have jumbo frames enabled. They have verified an MTU of 9000 on both the Linux client and the broadcast domain on the NetApp ONTAP 9.8 cluster.

Referring to the exhibit, which ONTAP command will help isolate a possible MTU mismatch?

A.

B.

C.

D.

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 2

A 2-node cluster hosts only NAS data UFs. All nodes lose access to the cluster network.

Referring to the exhibit, which statement is correct?

A. Both nodes race to takeover the other, one node will takeover the other node. B. No takeover event will occur and NAS data UFs will not be accessible. C. All nodes in the cluster reset and NAS data UFs are not accessible after reboot. D. NAS data UFs are accessible on only the node that has Epsilon.

Discussion 0

Correct Answer: D Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 3

Your customer complains that u host will constantly report losing a connection to the iSCSl target and then report that the session was reestablished.

As shown in the exhibit, what is a cause of this flapping?

A. A host with an IP address of 172.20.10.80 and a second host with an IP address of 10.10.20.60 are accessing the same LUN. B. A host with an IP address of 172.20.10.80 and a second host with an IP address of 10.10.20.60 are in different initiator groups. C. A host with an IP address of 172.20.10.80 and a second IP address of 10.10.20.60 is accessing different LUNs. D. A host with an IP address of 172.20.10.80 and a second host with an IP address of 10.10.20.60 have the same IQN.

Discussion 0

Correct Answer: D Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 4

You have a customer complaining of long build times from their NetApp ONTAP-based datastores. They provided you packet traces from the controller and client. Analysis of these traces shows an average service response time of 1 ms. QoS output confirms the same. The client traces are reporting an average of 15 ms in the same time period.
In this situation, what would be your next step?

A. A sync core should be triggered. B. The client that reports high latency should be investigated. C. The cluster interconnects should be investigated. D. The cluster is responding slowly and requires further investigation using performance archives.

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 5

Recently, a CIFS SVM was deployed and is working. The customer wants to use the Dynamic DNS (DDNS) capability available in NetApp ONTAP to easily advertise both data UFs to their clients. Currently. DNS is only responding with one data LIF. DDNS is enabled on the domain controllers.

Referring to the exhibit, which two actions should be performed to enable DDNS updates to work? (Choose two.)

A. Remove the NFS protocol from the cifs_01 data LIF. B. Disable the -vserver-fqdn parameter for the SVM DDNS services. C. Enable the -use-secure parameter for the SVM DDNS services. D. Enable the -is-enabled parameter for the SVM DDNS services

Discussion 0

Correct Answer: A,D Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 6

A customer with an FC MetroCluster configuration that is running NetApp ONTAP 9.8 software experienced a site outage and wants to know why the MetroClusler configuration did not switch over to the other site.
What are two reasons for this problem? (Choose two.)

A. An ISL link was not operating at 16Gbps. B. There was a failed PSU in the switchover site. C. The site had unmirrored aggregates. D. The ISLs were down between the sites.

Discussion 0

Correct Answer: C,D Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 7

A customer is calling you to troubleshoot why users are unable to connect to their CIFS SVM.

Referring to the Information shown in the exhibit, what Is the source of the problem?

A. The aggregate aggr2 has a failed disk. B. The broken disk in Node03 is the source of the problem. C. The databases On Node03 must be Switched from secondary to master. D. The v1db database is offline.

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).