Tibco Rendezvous 7 Certification - TB0-106 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

What are the two most efficient ways to label fields to allow the receiving application to search for specific fields? (Choose two.)

A. use field identifiers, if there are 17 or more fields B. use field names, if the field name length is less than 16 characters C. use field names, if there are 16 or fewer fields D. use field identifiers, if there are 16 or fewer fields E. use field identifiers, if the field identifier length is less than 16 characters F. use field names, if there are 17 or more fields

Discussion 0

Correct Answer: A,C Vote an answer

Question 2

Which field should you check to identify the cause of a sequence gap that occurred to determine if it is rvtrace or the network infrastructure that is dropping packets?

A. Data B. Multicast C. Rdata D. Bad packets

Discussion 0

Correct Answer: C Vote an answer

Question 3

What must you do to test TIBCO Rendezvous Direct Communication transport with rvperf?

A. specify multicast addressing in the -network parameter and do not include the -inbox parameter B. specify a two part -service parameter and do not include the -inbox parameter C. specify a two part -service parameter and include the -inbox parameter D. specify multicast addressing in the -network parameter and include the -inbox parameter

Discussion 0

Correct Answer: C Vote an answer

Question 4

Which two are contained in a TIBCO Rendezvous Certified Messaging (CM) ledger file on both the sender and receiver endpoints? (Choose two.)

A. CM owner name B. timeout C. message data D. certified listener list E. subject name

Discussion 0

Correct Answer: A,E Vote an answer

Question 5

Which three statements are true about a TIBCO Rendezvous daemon on a computer with more than one network interface? (Choose three.)

A. When IP software presents an inbound packet to a client program (such as RVD) it does not include any indication of the network on which that packet arrived. B. When sending an outbound broadcast packet, IP software sends the packet on multiple networks. C. TIBCO Rendezvous programs must not attempt to combine communications over different network interfaces using the same UDP or PGM service. D. When sending an outbound broadcast packet, IP software needs to use service parameters, not network parameters. E. When IP software presents an inbound packet to a client program (such as RVD), it includes the network on which that packet arrived. F. When sending an outbound broadcast packet, IP software sends the packet on only one network.

Discussion 0

Correct Answer: A,C,F Vote an answer

Question 6

What are two possible reasons for DATALOSS advisories? (Choose two.)

A. Some hardware component is experiencing intermittent failures; the component could be a faulty network card, a loose connection, or a frayed wire. B. The TIBCO Rendezvous daemon is running with a -reliability parameter that is too long. C. A TIBCO Rendezvous daemon process is starved for CPU cycles; either its host computer is too heavily loaded, or the priority of the daemon process is too low. D. The client is disconnected from thervd.

Discussion 0

Correct Answer: A,C Vote an answer

Question 7

Rendezvous distributed queues _____.

A. may use ledger files depending on the way it is configured B. use ledger files C. use ledger files only when certified messaging is used in the distributed queue D. do not use ledger files

Discussion 0

Correct Answer: D Vote an answer

Question 8

Which two statements are true for a virtual circuit? (Choose two.)

A. Attempting to send messages before the virtual circuit connection is complete produces error status. B. Virtual circuit can use multiple Rendezvous transports to make a connection. C. Messages can be sent before virtual circuit is complete. Messages will be stored locally until the connection is complete. D. Programs may create listener objects on virtual circuit transports at any time after the create call returns.

Discussion 0

Correct Answer: A,D Vote an answer