VMware Certified Professional 5 - Data Center Virtualization Delta - VCP550D FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

Why would an administrator be unable to locate an IP address for a vSphere vmnic uplink?

A. IP addresses are defined at the virtual nic level, not the vmnic level. B. ESXi host vmnics communicate with physical switches on layer 3. C. The IP address of the vmnic is not shown in the vSphere Client. D. ESXi hosts use NAT translation to mask the actual vmnic IP address.

Discussion 0

Correct Answer: A Vote an answer

Question 2

Before upgrading from vCenter 4.x to 5.x, an administrator runs the vCenter Host Agent Pre-Upgrade Checker. The Checker reports an issue.
What would cause the vCenter Host Agent Pre-Upgrade Checker to report an issue?

A. The file system is not intact. B. The .NET framework 3.5 is installed. C. The host network card is only 1 Gbps. D. The VMFS file system is version 4.0.

Discussion 0

Correct Answer: A Vote an answer

Question 3

A new LUN from an existing storage array is presented to a vSphere cluster. A vSphere administrator determines that the LUN is visible on all but one ESXi host in the cluster. The affected host is able to see existing LUNs presented from the same storage array.
What is the most likely cause?

A. The HBA in the host is incompatible with ESXi. B. The ESXi host has NOT been rebooted. C. LUN Masking is improperly configured on the storage array. D. The SAN fabric is improperly zoned.

Discussion 0

Correct Answer: C Vote an answer

Question 4

A virtual machine has the following configuration:
Thin provisioned virtual disks
The VMFS datastore on which it resides is on a thin provisioned LUN.
The storage array is VAAI-enabled.
What is the behavior of the virtual machine when it encounters an out-of-space condition?

A. It is powered off. B. It is converted to space-efficient sparse. C. It is suspended. D. It is gracefully shut down.

Discussion 0

Correct Answer: C Vote an answer

Question 5

An administrator is migrating 135 virtual machines from a vSphere Standard Switch to a vSphere Distributed switch. The migration reports an error and only some of the virtual
machines are transferred.
What is causing the error to occur?

A. The port group on the vSphere Distributed Switch was not configured with an Elastic port binding. B. The switch has become disconnected from an ESXi host. C. The virtual machine that failed to transfer did not have a network adapter. D. The vSphere Distributed Switch was created with a single, default port group.

Discussion 0

Correct Answer: D Vote an answer

Question 6

What is the purpose of configuring a VMkernel port for Fault Tolerance logging?

A. The selected vmkernel port is able to maintain a log of changes to the secondary virtual machine. B. The selected vmkernel port is able to log Fault Tolerance events to a syslog server. C. The selected vmkernel port is used to send external inputs from a primary virtual machine to its secondary counterpart. D. The selected vmkernel port is used to trigger a failover from the primary machine if a hardware crash occurs.

Discussion 0

Correct Answer: C Vote an answer

Question 7

An administrator is re-provisioning an ESXi host and moving it to another datacenter.
Which DCUI option should the administrator use to revert the system configuration to the default settings?

A. Renew Default System Configuration B. Reset System Configuration C. Revert System Configuration D. Rebuild Default System Configuration

Discussion 0

Correct Answer: B Vote an answer

Question 8

Which statement is accurate when choosing the storage controller for a virtual machine using the Create New Virtual Machine wizard in custom mode?

A. The controller options presented will be based on the guest OS type. The administrator must choose one of these options. B. There is a predetermined controller based on the guest OS, which can only be changed after the virtual machine is deployed. C. There is a predetermined controller based on the guest OS, which cannot be changed. D. A controller is recommended based on the guest OS type. The administrator can choose this controller or select any other.

Discussion 0

Correct Answer: D Vote an answer

Question 9

Which two statements accurately describes step that are taken to recover a virtual machine using vSphere Replication? (Choose two.)

A. Upon recovery, the virtual machine is automatically attached to it's configured network. B. A recovery is initiated from the target site. C. Upon recovery, the virtual machine must be manually attached to a network. D. A recovery is initiated from the source site.

Discussion 0

Correct Answer: B,C Vote an answer

Question 10

What will cause the validation of a vMotion migration to fail?

A. A virtual machine configured with a shared Raw-Device Mapped disk B. A virtual machine configured with a local .vswp file C. A virtual machine configured for CPU affinity D. A virtual machine configured to use NUMA

Discussion 0

Correct Answer: C Vote an answer

Question 11

A VMware administrator determines that a low priority virtual machine is negatively affecting the disk I/O performance of a higher priority virtual machine. The virtual machines are hosted on the same datastore presented to the same ESXi host.
Which configuration option should the VMware administrator use to resolve this issue?

A. Enable vSphere APIs for Array Integration (VAAI). B. Create a Storage Profile for each priority level. C. Increase the disk share value for the high priority VM. D. Migrate the low priority VM to another ESXi host.

Discussion 0

Correct Answer: C Vote an answer

Question 12

Which statement is true about the hardware configuration for ESXi hosts participating in a virtual SAN?

A. The hosts must have identical hardware. B. Each host must have a RAID Controller. C. The hosts must have network attached storage. D. Each host must have at least one Solid State Drive (SSD).

Discussion 0

Correct Answer: D Vote an answer