Exam 350-401 Topic 5 Question 107 Discussion

Actual exam question for Cisco's 350-401 exam
Question #: 107
Topic #: 5
Refer to the exhibit.

After configuring HSRP an engineer enters the show standby command. Which two facts are derived from the output? (Choose two.)

Suggested Answer: B,E Vote an answer

HSRP (Hot Standby Router Protocol) is a Cisco proprietary redundancy protocol for establishing a fault-tolerant default gateway. The protocol establishes a framework between network routers to achieve default gateway failover if the primary gateway becomes inaccessible.
* B: If Fa0/0 is shut down, the HSRP priority on R2 becomes 80. This is because interfaces going down can trigger a priority decrement in HSRP, which is often configured with the standby <group number> track <interface> <decrement value> command.
* E: R2 is using the default HSRP hello and hold timers. The default hello time is 3 seconds, and the hold time is 10 seconds. These values can be seen in the output of the show standby command if they are not explicitly configured to different values.

by Henry at Apr 11, 2025, 06:12 PM

Limited Time Offer

15%

Off

Get Premium 350-401 Questions as Interactive Self Test Engine or PDF

Comments

Chosen Answer:
This is a voting comment (?) , you can switch to a simple comment.
Switch to a voting comment New
Nick name: Submit Cancel
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
0
0
0
10