Exam 100-101 Topic 9 Question 79 Discussion

Router>enable Router#config terminal Router(config)#hostname Apopka 2) Enable-secret password (cisco10): Apopka(config)#enable secret cisco10 3) Set the console password to RouterPass: Apopka(config)#line console 0 Apopka(config-line)#password RouterPass Apopka(config-line)#login Apopka(config-line)#exit 4) Set the Telnet password to scan90: Apopka(config)#line vty 0 4 Apopka(config-line)#password scan90 Apopka(config-line)#login Apopka(config-line)#exit 5) Configure Ethernet interface (on the right) of router Apopka: The subnet mask of the Ethernet network 209.165.201.0 is 27. From this subnet mask, we can find out the increment by converting it into binary form, that is /27 = 1111 1111.1111 1111.1111 1111.1110 0000. Pay more attention to the last bit 1 because it tells us the increment, using the formula: Increment = 2place of the last bit 1 (starts counting from 0,from right to left), in this case increment = 25 = 32. Therefore: Increment: 32 Network address: 209.165.201.0 Broadcast address: 209.165.201.31 (because 209.165.201.32 is the second subnetwork, so the previous IP - 209.165.201.31 - is the broadcast address of the first subnet). -> The second assignable host address of this subnetwork is 209.165.201.2/27 Assign the second assignable host address to Fa0/0 interface of Apopka router: Apopka(config)#interface Fa0/0 Apopka(config-if)#ip address 209.165.201.2 255.255.255.224 Apopka(config-if)#no shutdown Apopka(config-if)#exit 6) Configure Serial interface (on the left) of router Apopka: Using the same method to find out the increment of the Serial network: Serial network 192.0.2.128/28: Increment: 16 (/28 = 1111 1111.1111 1111.1111 1111.1111 0000) Network address: 192.0.2.128 (because 8 * 16 = 128 so 192.0.2.128 is also the network address of this subnet) Broadcast address: 192.0.2.143 -> The last assignable host address in this subnet is 192.0.2.142/28. Assign the last assignable host address to S0/0/0 interface of Apopka router: Apopka(config)#interface S0/0/0 (or use interface S0/0 if not successful) Apopka(config-if)#ip address 192.0.2.142 255.255.255.240 Apopka(config-if)#no shutdown Apopka(config-if)#exit 7) Configure RIP v2 routing protocol: Apopka(config)#router rip Apopka(config-router)#version 2 Apopka(config-router)#network 209.165.201.0 Apopka(config-router)#network 192.0.2.128
Apopka(config-router)#end
Save the configuration:
Apopka#copy running-config startup-config
Finally, you should use the ping command to verify all are working properly!