Exam NSE7_EFW-7.2 Topic 1 Question 24 Discussion

Actual exam question for Fortinet's NSE7_EFW-7.2 exam
Question #: 24
Topic #: 1
Refer to the exhibit, which shows an error in system fortiguard configuration.

What is the reason you cannot set the protocol to udp in config system fortiguard?

Suggested Answer: D Vote an answer

The reason for the command failure when trying to set the protocol to UDP in theconfig system fortiguardis likely that UDP is not a protocol option in this context. The command syntax might be incorrect or the option to set a protocol for FortiGuard updates might not exist in this manner.
So the correct answer is D. udp is not a protocol option.

by abdulla at Feb 03, 2024, 05:25 AM

Limited Time Offer

15%

Off

Get Premium NSE7_EFW-7.2 Questions as Interactive Self Test Engine or PDF

Comments

Chosen Answer:
This is a voting comment (?) , you can switch to a simple comment.
Switch to a voting comment New
Nick name: Submit Cancel
abdulla
2024-02-03 05:25:46
Selected Answer: B
"To change the fortiguard port, you have to disable "fortiguard-anycast" option under fortiguard settings then only; the FortiOS will allow to change the protocol to UDP."
upvoted 1 times
...
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
0
0
0
10