Exam ISTQB-CTFL Topic 1 Question 318 Discussion

Actual exam question for ISTQB's ISTQB-CTFL exam
Question #: 318
Topic #: 1
The following diagram displays the logical dependencies between requirements and the individual requirement priorities. For example, "R2->R3" means that R3 is dependent on R2. Priority is indicated by the number next to the letter "P" i.e. P1 has a higher priority than P2.
Which one of the following options best describes the test execution sequence using both requirement dependency and priority

Suggested Answer: D Vote an answer

The correct test execution sequence should consider both the dependencies between the requirements and their priorities. According to the diagram, the sequence begins with R2 (P1) as it is a prerequisite for R3 (P4).
Then R1 (P3) can be tested. R3 follows as it depends on R2. Next, R7 (P4) should be tested before R6 (P3) and R5 (P2), as indicated by their dependencies. Finally, R4 (P1) and R8 (P1) can be tested. Therefore, the best sequence is R2, R1, R3, R7, R6, R5, R4, R8.Reference:ISTQB CTFL Syllabus V4.0, Section 5.1.5

by Kelly at Aug 08, 2025, 03:17 AM

Limited Time Offer

15%

Off

Get Premium ISTQB-CTFL Questions as Interactive Self Test Engine or PDF

Comments

Chosen Answer:
This is a voting comment (?) , you can switch to a simple comment.
Switch to a voting comment New
Nick name: Submit Cancel
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
0
0
0
10