Prev Next Question 38/167 - 4A0-104.v2019-05-14

Click on the exhibit button below.

If CE1 and PE1 use BGP to exchange routing information and CE2 and PE2 use static routing to forward
traffic to and from the VPRN, which of the following statements is considered TRUE?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (167q)
Question 1: Click on the exhibit button below. (Exhibit) Assuming the cu...
Question 2: 3 Epipe services and 2 VPLS services have been configured be...
Question 3: When configuring distributed services across a network, it i...
Question 4: The SAP 1/1/1:2.3 receives an untagged Ethernet frame. Which...
Question 5: Which of the following about VPLS MAC learning is FALSE?...
Question 6: A VPLS receives a frame with the single VLAN tag 35 on the Q...
Question 7: What is the minimum Ethernet physical network MTU required f...
Question 8: Which of the following SAP encapsulations support multiple s...
Question 9: Click the exhibit. (Exhibit) Based on the output shown, what...
Question 10: What command syntax would be used to create a new IES servic...
Question 11: On an Alcatel-Lucent 7750 SR, what is the recommended approa...
Question 12: How many service labels must be signaled to bring up a fully...
Question 13: Click the exhibit. (Exhibit) This output is from a router th...
Question 14: How many SAPs can be configured on a port configured with do...
Question 15: Which of the following best describes how a MAC FDB is popul...
Question 16: Which protocol is used to signal the outer label for a VPN s...
Question 17: A VPLS has a service MTU of 1600. To create an IES spoke ter...
Question 18: Which of the following about VPLS MAC learning is TRUE?...
Question 19: Which one of the following commands on an Alcatel-Lucent 775...
Question 20: Which routing protocol cannot be run over an Ipipe?...
Question 21: Port 1/1/1 has been configured as an access port with encaps...
Question 22: Which of the following about Hierarchical VPLS is FALSE?...
Question 23: Which of the following commands would be used to show the op...
Question 24: On the Alcatel-Lucent 7750 SR, which of the following statem...
Question 25: In a Layer 2 encapsulation using T-LDP, what does the first ...
Question 26: Which of the following about ADSPEC is FALSE?...
Question 27: Click the exhibit. (Exhibit) Both clips of output are from r...
Question 28: Click the exhibit button. (Exhibit) Part of a 6VPE deploymen...
Question 29: Which of the following about transport and service tunnels i...
Question 30: What is the purpose of service mirroring on the Alcatel-Luce...
Question 31: Click the exhibit. (Exhibit) The output is from PE router R1...
Question 32: Which of the following is NOT a benefit of "Hub and Spoke'' ...
Question 33: What must be configured before a SAP can be created on an E-...
Question 34: Which of the following best describes a MAC FDB used by a VP...
Question 35: Which of the following best describes the label stack for a ...
Question 36: Which of the following about the Alcatel-Lucent 7750 SR svc-...
Question 37: Which of the following about the VPRN data plane is TRUE?...
Question 38: Click on the exhibit button below. (Exhibit) If CE1 and PE1 ...
Question 39: Which of the following about VPRN labels is FALSE?...
Question 40: Which of the following commands is used to configure a new M...
Question 41: What is the best approach of making MTUs match between a VPL...
Question 42: Which of the following commands is required to configure an ...
Question 43: Which of the following about SDPs is FALSE?...
Question 44: On an Alcatel-Lucent 7750 SR, which of the following about I...
Question 45: In a Layer 2 encapsulation, using Martini, what does the sec...
Question 46: Which of the following SAP encapsulations does NOT support m...
Question 47: How many service labels must be signaled to bring up a fully...
Question 48: Which of the following statements is TRUE concerning the adv...
Question 49: Click the exhibit. (Exhibit) The operator at PE1 wants to an...
Question 50: Which utility on the Alcatel-Lucent 7750 SR can be used to i...
Question 51: Click the exhibit. (Exhibit) The output is from PE router R1...
Question 52: How many service labels must be signaled to bring up a fully...
Question 53: By default, what does the Alcatel-Lucent 7750 SR do when a f...
Question 54: Which of the following commands is used to enable an Epipe s...
Question 55: Which of the following statements is NOT a valid reason to u...
Question 56: Click the exhibit. (Exhibit) Based on the output from PE rou...
Question 57: Click the exhibit. (Exhibit) Assuming CE1 exports its system...
Question 58: Which of the following statements best describes an FDB used...
Question 59: Which of the following about IES is TRUE?...
Question 60: Which of the following commands is used to create a new Epip...
Question 61: Click the exhibit. (Exhibit) This output is from PE router R...
Question 62: Why must the MTU be changed when configuring an IES spoke te...
Question 63: Which of the following about configuring a distributed E-pip...
Question 64: Which of the following are characteristics of an IES service...
Question 65: Which of the following best describes a VPWS?...
Question 66: An IPv4 MPLS provider network is being configured for 6VPE. ...
Question 67: Which VPWS service would be used to create a point-to-point ...
Question 68: Which of the following about route distinguishes on the Alca...
Question 69: Choose the following components that are necessary for the c...
Question 70: What Alcatel-Lucent 7750 SR OAM tool can be used to verify t...
Question 71: Which of the following statements are TRUE regarding a fully...
Question 72: Which of the following is a benefit of VPRN as compared to V...
Question 73: Which of the following statements is TRUE regarding service ...
Question 74: Which of the following about dot1Q SAPs is FALSE?...
Question 75: What happens by default on an Alcatel-Lucent 7750 SR when a ...
Question 76: The terms "customer" and "service" are used synonymously whe...
Question 77: Which of the following about the Alcatel-Lucent 7750 SR sdp-...
Question 78: A mesh SDP is used to create an Fpipe service....
Question 79: Which of the following is NOT a VPWS service supported on th...
Question 80: A service has a null encapsulated SAP and a vc-type vlan' SD...
Question 81: Which of the following can be used to detect the smallest pa...
Question 82: An E-pipe is configured with a service MTU of 5000. What MTU...
Question 83: Which of the following must be configured when configuring a...
Question 84: Click the exhibit. (Exhibit) Part of a 6VPE deployment is sh...
Question 85: Which of the two following statements are TRUE?...
Question 86: A VPRN service is configured with BGP used as the CE-PE rout...
Question 87: Which of the following statements is TRUE regarding a VRF?...
Question 88: On an Alcatel-Lucent 7750 SR, the OAM command 'svc-ping' can...
Question 89: Which of the following commands would be used to configure a...
Question 90: An ES service can have both MAC and IP filters applied to it...
Question 91: Which of the following best describes a VPLS?...
Question 92: Which command provides a summary status of the VPLS service ...
Question 93: Which of the following statements is TRUE concerning route d...
Question 94: Which of the following statements best describes the floodin...
Question 95: Which of the following about SDPs is FALSE?...
Question 96: Which of the following about IES is FALSE?...
Question 97: Which of the following options are used to configure an MPLS...
Question 98: In a Layer 2 VPN service, the FCS is stripped when a custome...
Question 99: A technician sitting in a Network Operations Center would li...
Question 100: Which of the following is a characteristic of a VPLS?...
Question 101: Click the exhibit. (Exhibit) E-pipe 100 is using an SDP (4) ...
Question 102: Which of the following about VPRN route targets is FALSE?...
Question 103: How many SAPs can be configured on a port configured with NU...
Question 104: Which of the following about the label stack of a VPRN is FA...
Question 105: What can the sdp-ping command be used for? (Choose 2)...
Question 106: Which of the following statements is FALSE regarding 6VPE?...
Question 107: Click on the exhibit button below. (Exhibit) Which of the fo...
Question 108: The SAP 1/1/1:2.3 receives an Ethernet frame with outer VLAN...
Question 109: Fragmentation is supported on a Layer 2 service...
Question 110: Which of the following about SAPs is FALSE?...
Question 111: Which of the following steps is mandatory when enabling an M...
Question 112: Which of the following statements best describes the main di...
Question 113: Which of the following statements is FALSE regarding 6VPE?...
Question 114: Which of the following statements is FALSE regarding SAPs?...
Question 115: On which object is ADSPEC enabled?...
Question 116: Which protocol is used to signal the inner label for a L2-VP...
Question 117: When a physical port is configured for null encapsulation, m...
Question 118: Which of the following tasks must be carried out before dele...
Question 119: Which of the following statements are TRUE about configuring...
Question 120: FRF.5 is a standard that describes which of the following re...
Question 121: Which of the following about the BGP VPN-IPv4 address family...
Question 122: Click the exhibit. (Exhibit) Which tool produced this output...
Question 123: By default, what does a PE do to support VPLS services for d...
Question 124: Which of the following commands is used in an RSVP signaled ...
Question 125: Which of the following statements about VPRN is NOT true? (C...
Question 126: Click on the exhibit button below. (Exhibit) Is a routing po...
Question 127: Customer 'A' has sites on 3 different Alcatel-Lucent PE rout...
Question 128: A transport tunnel can either use an MPLS or GRE encapsulati...
Question 129: Which of the following about the components of a service on ...
Question 130: Which of the following SAPs will forward tagged frames with ...
Question 131: Which of the following statements best describes the floodin...
Question 132: On an Alcatel-Lucent 7750 SR, why must the MTU be explicitly...
Question 133: Which of the following about VPRN VRF tables is FALSE?...
Question 134: What is the minimum Ethernet physical network MTU required f...
Question 135: What is a key benefit of a VPLS service?...
Question 136: Which of the following about IES is FALSE?...
Question 137: Click the exhibit. (Exhibit) An operator at PE1 wants to ana...
Question 138: Which of the following about VPRN VRF tables is FALSE?...
Question 139: Click the exhibit. (Exhibit) Which tool produced this output...
Question 140: Which of the following SAPs will NOT forward untagged frames...
Question 141: Which protocol is used to signal the service label for a Lay...
Question 142: SAPs in an Epipe service can only be configured on Ethernet ...
Question 143: Which of the following about VPRNs is TRUE?...
Question 144: Which of the following commands is used to configure the enc...
Question 145: An operator wishes to verify end-to-end connectivity for an ...
Question 146: Click the exhibit. (Exhibit) The operator at PE1 wants to an...
Question 147: Click the exhibit. (Exhibit) Routes are exchanged between CE...
Question 148: A SAP configured in the form of 1/1/1:0/32 would be used for...
Question 149: A service provider wishes to configure a Layer 2 service tha...
Question 150: Click the exhibit. (Exhibit) The two PEs are providing 6VPE ...
Question 151: Which service type is needed to bridge an ATM-attached user ...
Question 152: Which of the following about route distinguishes on the Alca...
Question 153: Click on the exhibit button below. (Exhibit) Which of the fo...
Question 154: Which of the following statements best describes a route tar...
Question 155: By default, what does an Alcatel-Lucent 7750 SR do to suppor...
Question 156: Which of the following items can NOT be used as a mirror sou...
Question 157: A customer requests that their Layer 2 Ethernet service be c...
Question 158: Which of the following regarding 6VPE is FALSE?...
Question 159: What does a PE do when a frame is received in a VPLS service...
Question 160: Which of the following defines a SAP that will select frames...
Question 161: Which of the following statements are FALSE regarding the VP...
Question 162: Which of the following SAPs will forward all tagged and unta...
Question 163: Consider an E-pipe service configured with SAP 1/1/1:5 and S...
Question 164: Which of the following about SDPs is FALSE?...
Question 165: What happens by default on an Alcatel-Lucent 7750 SR when a ...
Question 166: Which of the following statements is TRUE about the VRF?...
Question 167: Which of the following fields is NOT present in a GRE encaps...