ExtremeNetworks.EW0-300.v2019-06-23.q88

Exam Code:EW0-300
Exam Name:Extreme Networks Specialist....
Certification Provider:Extreme Networks
Free Question Number:88
Version:v2019-06-23
Rating:
# of views:147
# of Questions views:1681
Start Practice Test

Valid EW0-300 Dumps shared by PrepAwayExam.com for Helping Passing EW0-300 Exam! PrepAwayExam.com now offer the newest EW0-300 exam dumps, the PrepAwayExam.com EW0-300 exam questions have been updated and answers have been corrected get the newest PrepAwayExam.com EW0-300 dumps with Test Engine here:

Access Premium Version
(158 Q&As Dumps, 40%OFF Special Discount: freecram)

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Exam Question List
Question 1: Select the incorrect statement for PIM....
Question 2: In a stable OSPF network, all OSPF routers in the same area ...
Question 3: The IS-IS Routing Protocol has been developed in ISO to prov...
Question 4: The Skew time in VRRP is used to ensure that two back-up rou...
Question 5: In normal operation the master node in the EAPS ring blocks ...
Question 6: In Extreme Ware what is the normal ACL behavior for incoming...
Question 7: The following ExtremeWare components are required on Extreme...
Question 8: IGMP v1 supports the leave group message....
Question 9: Which of the following is the default ESRP priority setting ...
Question 10: _________ is an ESRP option that allow(s) multiple VLANs to ...
Question 11: What is the meaning of the IEEE 802.3 SNAP field in an Ether...
Question 12: On an Extreme Networks switch, how many bits comprise an OSP...
Question 13: Although you can specify sequence numbers for different ACL ...
Question 14: An OSPF router connected to a RIP network & performing r...
Question 15: A stream of IP Multicast packets is addressed to...
Question 16: What are the differences between a Summit 48i and a Summit 4...
Question 17: The Alpine 3802 switch contains a 3-slot chasis that can be ...
Question 18: What are the advantage/s of using integrated IS-IS as a rout...
Question 19: Which of the following is not advertised in an OSPF Link Sta...
Question 20: What is true of a Rendezvous Point in PIM-DM?...
Question 21: Radius on Extreme Networks 'i" Chipset switches allows valid...
Question 22: In general IS-IS allows routing of both IP and OSI packets. ...
Question 23: When you create an ACL entry on Summit 48i switch it works i...
Question 24: How does an IGMP router learns about the existence of hosts ...
Question 25: The Address Resolution Protocol enables a device to learn a ...
Question 26: Which of the following items is included in a DVMRP routing ...
Question 27: When the CLI command show vlan corporate, is issued, the Pro...
Question 28: What mechanisms does a master node use to detect a failure i...
Question 29: In SLB, Port Translation Mode is similar to Translation Mode...
Question 30: SSH2 on Extreme Networks 'i' series chipset switches enables...
Question 31: in IS-IS level 1/2 routers act as border routers to their re...
Question 32: Which CLI command enables all multicast traffic to multicast...
Question 33: Extreme Networks "I" Chipset switches allows you to run simu...
Question 34: (Exhibit) According to accompanying diagram and ACL configur...
Question 35: On a RADIUS server you can distinguish between switch access...
Question 36: IS-IS routing uses two levels of hierarchical routing level ...
Question 37: Within VRRP the election process of becoming the master swit...
Question 38: A QoS policy is the result when you assign a traffic groupin...
Question 39: All Extreme switch products support the standard 802.1p prio...
Question 40: By default, the OSPF routerID for an Extreme switch is selec...
Question 41: A QoS profile determines into which hardware queue a frame i...
Question 42: By default all VLANs are assigned to QoS profile QP...
Question 43: When a PIM-SM router wants to receive a Multicast stream, it...
Question 44: Like OSPF stub areas, NSSA areas cannot be used as transit a...
Question 45: Select the statements that are true for IP multicast?...
Question 46: In PIM sparse mode the Bootstrap Router election is based on...
Question 47: The pre-empt option in VRRP is enabled by default on Extreme...
Question 48: In OSPF, the router type that is required to connect an area...
Question 49: What is the maximum number of ACL rules supported on an Extr...
Question 50: OSPF Hello packets are recognized by all routers in the same...
Question 51: The type of OSPF LSAs that are sent out within an automous s...
Question 52: What is the RP-set?
Question 53: The CLI Command configure ospf delete vlan all? Will do the ...
Question 54: Which of the following CLI commands could you use to determi...
Question 55: There is one ACL type supported by Extreme Networks switches...
Question 56: Is it possible to configure a single physical port into diff...
Question 57: The following CLI command is valid to advertise SLB virtual ...
Question 58: Select the correct statements related to IP Multicast?...
Question 59: Which statement is true about integrated IS-IS....
Question 60: What does IS-IS stand for?
Question 61: In SLB a virtual server cannot belong to the same VLAN as th...
Question 62: In a Summit 5i switch, a QoS policy is applied on a basis....
Question 63: When limit-learning is configured on a port and the limit is...
Question 64: When configuring a Summit 5i for OSPF routing, it is recomme...
Question 65: The integrated IS-IS protocol allows for mixing of IP-only,O...
Question 66: Unlike VRRP, the eExtreme Standby Router Protocol provides r...
Question 67: An IP-only IS-IS router (or "IP-only" router) is defined to ...
Question 68: The Summit 7i switch supports how many queues per interface?...
Question 69: What is the CLI command you would use to configure a VLAN to...
Question 70: Dealing with access control lists on Extreme Networks switch...
Question 71: When SSH2 is configured and enabled on a Summit 7i switch, t...
Question 72: OSPF requires that all areas attach directly to the backbone...
Question 73: An LSP is a link state packet used by which routing protocol...
Question 74: What is the function of a Bootstrap Router?...
Question 75: When you configure EAPS the following must apply....
Question 76: Dealing with an Access Control List on Extreme switches it's...
Question 77: Is it possible to create multicast STPD on a switch?...
Question 78: What is an IGP protocol other than OSPF that uses the Dijkst...
Question 79: A QoS building block that defines a class of service by spec...
Question 80: The default OSPF router dead interval for Extreme Networks s...
Question 81: Which CLI command would you use to configure vlan tracking t...
Question 82: DVMRP is similar to OSPF in that it is Link State based....
Question 83: VRRP is
Question 84: IP Version 6 has amongst other differences with IP Version 4...
Question 85: What configuration is send when you upload a configuration f...
Question 86: Manual replication of saved images and configurations from t...
Question 87: The DHCP, HTTP and RADIUS functions that are required for Ne...
Question 88: What does the abbreviation DVMRP stands for?...