Cisco Implementing Cisco Video Network Devices (VIVND) - 200-001 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

You are troubleshooting an issue and you need to connect to presentation codec via CLI. Which CLI command allows you to connect to the presentation codec?

A. utils presentation system B. set system presentation C. utils system presentation D. utils connect presentation E. utils presentation connect

Discussion 0

Correct Answer: C Vote an answer

Question 2

Which Cisco TelePresence Multipoint Control Unit Layout view mode gives prominence to one conference participant over the other conference participants while still allowing conference participants to view multiple participants at the same time?

A. Room switching B. Enhanced continuous presence C. Active speaker D. Speaker switching E. Continuous presence

Discussion 0

Correct Answer: B Vote an answer

Question 3

When a call is placed from a Cisco VCS registered SIP-only endpoint to an H.323-only endpoint, which type of call license is consumed?

A. off-net call B. interworking call C. traversal call D. on-net call E. non-traversal call F. Cisco Unified Workspace Licensing

Discussion 0

Correct Answer: C Vote an answer

Question 4

When placing a call from Cisco Jabber Video for TelePresence to the Cisco TelePresence System Codec C40, which FECCs are available?

A. Left, right, up, down, zoom-in, and zoom-out are all available. B. No FECC is available. C. Only left and right are available. D. Only up and down are available. E. Only zoom-in and zoom-out are available.

Discussion 0

Correct Answer: A Vote an answer

Question 5

Refer to the exhibit.

Which Cisco Prime Collaboration capabilities are shown?

A. Dashboard view of overall voice and video network health B. Proactive monitoring and alerts for video endpoint faults C. End-to-end network path troubleshooting D. Endpoint and system inventory reporting E. Real-time monitoring and alerts for video endpoint faults

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 6

Refer to the exhibit.

You have just finished installing a 65-inch dual profile system in a multipurpose room. After powering up the entire system, only one display is used. Using the information in the exhibit, why is the second display not displaying anything from the system?

A. The display is not powered on. B. The dual display option key has not been input into the codec. C. The codec has the appropriate option keys installed, so either the display is not cabled correctly, the codec is configured incorrectly, or there is no input being sent to the display. D. The Cisco TelePresence profile systems do not support dual display.

Discussion 0

Correct Answer: C Vote an answer

Question 7

Refer to the exhibit.

Which two strings that could be dialed to start a multipoint conference that is hosted by the multipoint control unit? (Choose two.)

A. [email protected] B. 5919 C. 52900121 D. [email protected] E. [email protected] F. ex90

Discussion 0

Correct Answer: A,B Vote an answer

Question 8

Refer to the exhibit.

Which option performs a factory reset of a Cisco TelePresence System endpoint?

A. Configuration > Security Settings B. A Cisco TelePresence System endpoint can be reset only via CLI. C. Monitoring D. Troubleshooting > Hardware setup E. Configuration > System Settings F. Troubleshooting > System Restart G. Troubleshooting > Configuration Issues

Discussion 0

Correct Answer: G Vote an answer