EMC Specialist - Implementation Engineer, PowerMax and VMAX Family Solutions - DES-1121 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

What are the default settings for a Storage Group in PowerMax, VMAX All Flash, and VMAX3?

A. No SRP and no SL B. Default SRP and no SL C. No SRP and Optimized SL D. Default SRP and Optimized SL

Discussion 0

Correct Answer: D Vote an answer

Question 2

Two PowerMax arrays have been configured for replication using SRDF During a disaster recovery operation production has been transferred to the R2 devices at the target site. Which operation begins the transfer of accumulated invalid tracks from the R2s to the R1s while production work continues on the R2s?

A. Failover B. Resume C. Update D. Fallback

Discussion 0

Correct Answer: B Vote an answer

Question 3

What does a service level define*?

A. Expected average throughput for a disk group B. Expected average response time target for a Storage Group C. Expected average response time target for a disk group D. Expected average throughput for a Storage Group

Discussion 0

Correct Answer: B Vote an answer

Question 4

Which units of measure are used to specify the size type when creating volumes in Unisphere?

A. Cylinders, MB, GB, TB B. Cylinders, GB, TB. PB C. MB and GB only D. MB, TB, PB

Discussion 0

Correct Answer: B Vote an answer

Question 5

SRDF/A has been enabled between two PowerMax arrays in Multi-Session Consistency mode An extended loss of all RDF links occurs. What will the RDF pair states be after link connectivity is restored?

A. Failed Over B. Partitioned C. Split D. Suspended

Discussion 0

Correct Answer: B Vote an answer

Question 6

Which port flag is required for auto-provisioning?

A. ACLX B. SPC2 C. SC3 D. V

Discussion 0

Correct Answer: A Vote an answer

Question 7

A PowerMax administrator modified a Storage Group to add more volumes. The administrator then decides to use the Suitability Check to ensure compliance is met. The Suitability check runs but does not provide any information.
What is the likely cause for this issue?

A. Suitability Check was run before the Storage Group was configured B. Steps were skipped in the Modify Storage Group setup before running the Suitability Check C. Volumes were added to the Storage Group before using the Suitability report D. Array has not been registered for performance data collection

Discussion 0

Correct Answer: B Vote an answer

Question 8

What are the main options used to complete a configuration change using the synconfigure command?

A. preview query, reserve B. preview, prepare, commit C. preview query, commit D. preview, prepare, reserve

Discussion 0

Correct Answer: B Vote an answer