EMC Specialist - Implementation Engineer, Campus Networking - DES-5121 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

Which packet characteristics can policy-based routing be configured to match against?

A. TCP Port, L3 Packet Length, and 802.1p Priority B. TTL, TCP Port, and L3 Packet Length C. L3 Packet Length, TTL, and 802.1p Priority D. TCP Port, TTL, and 802.1p Priority

Discussion 0

Correct Answer: A Vote an answer

Question 2

A network administrator has configured a 4-port port-channel between two Dell EMC Campus networking switches. The physical interfaces show as administratively up and operationally up on both switches. However, the port-channel shows as operationally up on Switch A and operationally down on Switch B.
What is a potential reason for the inconsistent port-channel state?

A. Switch A is configured using channel-group # mode on and Switch B is configured using channel- group # mode auto B. N-Series supports a maximum number of physical interfaces that can be included in port-channels on a per-device basis C. Switch A is configured to use dynamic port-channels and Switch B is configured to use static port- channels D. Ports in the port-channel on Switch A are all the same speed but the ports in the port-channel on Switch B are a mix of speeds

Discussion 0

Correct Answer: A Vote an answer

Question 3

What is the typical sequence of steps to upgrade the firmware of a Dell EMC N-Series switch?

Discussion 0

Correct Answer:

Question 4

You are tasked with deploying a single Dell EMC N-Series switch with a 2-port port-channel to uplink to an existing upstream switch. The following reflects the upstream switch configuration:
N4032F#show running-config interface tengigabitethernet 1/0/5
channel-group 1 mode on
N4032F#show running-config interface tengigabitethernet 1/0/6
channel-group 1 mode on
Which type of port-channel should be configured to successfully uplink?

A. MLAG B. Passive C. Active D. Static

Discussion 0

Correct Answer: D Vote an answer

Question 5

A network administrator added a new Dell EMC N-Series switch into their network with RSTP configured. The spanning-tree priority on all existing switches has been left at the default value.
If the administrator wants this new switch to become the spanning tree root, which command should be used?

A. spanning-tree priority 61440 B. spanning-tree priority 36864 C. spanning-tree priority 32768 D. spanning-tree priority 4096

Discussion 0

Correct Answer: D Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 6

After setting up the VoIP configuration, a network administrator issues the following commands with the results shown:
console# show voice vlan
Administrative Mode...........................Enable
console# show voice vlan it gi 1/0/2
Interface........................................Gi1/0/2
Voice VLAN Interface Mode...............Enabled
Voice VLAN ID...............................10
Voice VLAN COS Overwrite...............False
Voice VLAN DSCP Value...................46
Voice VLAN Port Status.....................Enabled
Voice VLAN Authentication................Disabled
Based on this information, what is the Layer 3 QoS value?

A. 10 B. Gi1/0/2 C. 46 D. 5

Discussion 0

Correct Answer: C Vote an answer

Question 7

What is a recommended configuration for an MLAG peer-link on a Dell EMC N-Series switch?

A. Link must be a trunk port B. Link must contain multiple interfaces C. Spanning tree must be enabled D. Spanning tree must be disabled

Discussion 0

Correct Answer: C Vote an answer