EMC Specialist - Implementation Engineer, Data Center Networking - DES-5221 FREE EXAM DUMPS QUESTIONS & ANSWERS]

Question 1

Which configuration supports tagged frames on VLAN 20 and untagged frames on VLAN 5?

A. interface ethernet 1/1/9 switchport trunk allowed vlan 20 switchport access vlan 5 switchport mode trunk B. interface ethernet 1/1/9
switchport trunk mode allowed vlan 20 switchport access mode vlan 5 no shutdown C. interface ethernet 1/1/9 switchport mode trunk switchport trunk allowed vlan 20 switchport access vlan 5 D. interface ethernet 1/1/9
switchport trunk mode allowed vlan 20 switchport access vlan 5 no shutdown

Discussion 0

Correct Answer: C Vote an answer

Question 2

Which field in an IP header is used for QoS marking?

A. SA B. ToS C. CoS D. DA

Discussion 0

Correct Answer: B Vote an answer

Question 3

When installing OS10 on a switch from a USB drive, what format is used for the file system?

A. HFS B. NTFS C. HFS+ D. FAT32

Discussion 0

Correct Answer: D Vote an answer

Explanation: Only visible for FreeCram members. You can sign-up / login (it's free).

Question 4

Refer to the exhibit.

A default route exists on OS10-C that points all internet traffic towards 10.0.13.3 on OS10-B. A network administrator needs to re-route internet traffic only sourced from Host-1 to 10.0.12.2 on OS10-A instead. What feature can the administrator implement to accomplish this goal?

A. Policy-Based Routing B. Source-Based Routing C. Static Default Routing D. OSPF Cost Manipulation

Discussion 0

Correct Answer: A Vote an answer

Question 5

Refer to the exhibit.

What is the VRRP state of OS10-A after a router with a default VRRP admin priority with VRID100 comes online?

A. backup-state B. primary-state C. master-state D. standby-state

Discussion 0

Correct Answer: C Vote an answer

Question 6

What is required to enable ECMP in BGP?

A. Maximum-paths and multipath-relax commands. B. ECMP is not possible in BGP. C. Sub-interfaces must be configured on the physical interface running BGP. D. OSPF must install equal cost paths in the routing table for BGP to use ECMP.

Discussion 0

Correct Answer: A Vote an answer