(2024) NS0-184 Exam Dumps, Practice Test Questions BUNDLE PACK
NCSIE ONTAP Certification NS0-184 Sample Questions Reliable
NEW QUESTION # 21
Your customer currently has a 4-node AFF A400 cluster that runs ONTAP 9.8, with two NS224 shelves that are connected to each HA pair. The customer needs to add additional capacity to the cluster.
Which two actions would enable the customer to accomplish this task? (Choose two.)
- A. Deploy a new AFF A400 to the cluster.
- B. Connect the new NS224 shelves to the existing Cisco Nexus 3232C switches.
- C. Deploy new, dedicated, storage switches for the new NS224 shelves.
- D. Connect the new NS224 shelves to the existing NS224 shelves and adjust the shelf IDs.
Answer: A,D
NEW QUESTION # 22
You have installed a new 2-node FAS9000 cluster with two external shelves. You want to make sure that each node has two paths to each disk in the shelves.
How do you verify your configuration?
- A. Use the storage disk option show command.
- B. Use the storage show disk -p command.
- C. Use the disk show -fields initiator command.
- D. Use the sysconfig command.
Answer: C
NEW QUESTION # 23
Click the Exhibit button.
Which set of components on a FAS9000 are highlighted in the exhibit?
- A. SAS-Module, Controller, USB-Port, FlashCache-Module
- B. NVRAM-Module, Controller, Serial-Port, FlashCache-Module
- C. FCVI-Module, Controller, Serial-Port, FlashCache-Module
- D. Powersupply, Controller, USB-Port, NVRAM-Module
Answer: C
NEW QUESTION # 24
Which two switch operating system are supported on ONTAP cluster switches? (Choose two.)
- A. Cisco NX-OS
- B. Brocade FOS
- C. Cisco IOS
- D. Broadcom EFOS
Answer: A,D
NEW QUESTION # 25
You are using Broadcom BES-53248 switches for a cluster interconnect in a base configuration.
In this scenario, what is the minimum number of ISLs supported between the switches?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION # 26
You are setting up a new AFF A400 that will serve iSCSI LUNs. You will have four iSCSI SVMs that each need to connect to an Internet Storage Name Service (iSNS) for discovery and management purposes.
In this scenario, which network interface is needed for each SVM to register with the name service?
- A. node management LIF
- B. SVM management LIF
- C. intercluster LIF
- D. SVM data LIF
Answer: C
NEW QUESTION # 27
You have just racked a new 6-node switched cluster with ONTAP 9.7. You need to configure the cluster switches.
In this scenario, which two elements would be used to complete the configuration? (Choose two.)
- A. SSH
- B. rlogin
- C. SFP+ port
- D. serial port
Answer: A,D
NEW QUESTION # 28
You are installing an AFF A700 system with two disk shelves using ADPv2. After setting up the cluster, you realize that one drive shelf was powered off and that the drives have not been assigned to any of the nodes.
In this scenario, which two resources will help you find a solution? (Choose two.)
- A. NetApp Documentation Center
- B. NetApp Knowledge Base
- C. Active IQ Digital Advisor
- D. Active IQ Config Advisor
Answer: B,D
NEW QUESTION # 29
You have added two new AFF A250 nodes to an existing 4-node cluster with NetApp CN1610 cluster network switches. Although the nodes can join the cluster, the storage failover show command output shows that the NVRAM log is not synchronized, and it cannot reach the partner over an HA interconnect.
In this scenario, which two statements are true? (Choose two.)
- A. The AFF A250 requires switches with 40GbE port support.
- B. The AFF A250 requires switches with 25GbE port support.
- C. The AFF A250 uses the same port for the cluster and the HA interconnect.
- D. The AFF A250 uses different ports for the cluster and the HA interconnect.
Answer: B,D
NEW QUESTION # 30
You have a 2-node FAS8300 ONTAP 9.8 cluster that serves SMB shares. You are configuring interface groups for higher performance and resiliency.
Which two NetApp best practices should you follow to satisfy these performance and resiliency requirements? (Choose two.)
- A. Use ports with different chipsets.
- B. Use ports from the same NICs.
- C. Use ports from different NICs.
- D. Use ports with the same chipsets.
Answer: C,D
NEW QUESTION # 31
Click the Exhibit button.
You want to add a FAS2750 HA pair to an existing 6-node cluster.
Referring to the exhibit, which action would you perform to begin adding the node?
- A. Use the back command to begin the Cluster Setup wizard.
- B. Use the exit or quit commands then run the cluster setup command.
- C. Reboot the node and enter maintenance mode and run the Cluster Setup wizard.
- D. Use the node setup wizard and select 0a as the management interface.
Answer: D
NEW QUESTION # 32
Click the Exhibit button.
A customer has two Cisco 40GbE data switches. They want to connect the switches to an AFF A400 HA pair. The switches and the AFF A400 are approximately seven meters apart.
Referring to the exhibit, which two supported actions would allow you to accomplish this task? (Choose two.)
- A. Relocate the switches or the AFF A400 so that the distance is less than five meters.
- B. Change the requirement for Ethernet cables.
- C. Change the requirement for optical cables.
- D. Install 10 meter NetApp supported copper cables.
Answer: B,D
NEW QUESTION # 33
You are deploying a new AFF All SAN Array A250 into a customer's existing data fabric.
In this scenario, which two tools would give insight into their existing Cisco MDS fabric configuration? (Choose two.)
- A. Active IQ Config Advisor
- B. Cisco Data Center Network Manager (DCNM)
- C. Brocade SAN Health
- D. Active IQ
Answer: B,D
Explanation:
Reference:
https://www.cisco.com/c/en/us/products/collateral/servers-unified-computing/ucs-x-series-modular-system/flex-pod-datacenter-ucs-intersight.html
NEW QUESTION # 34
You want to ensure the highest path resilience and performance increase to the storage stack on your FAS8700 cluster.
In this scenario, which two types of stack cabling are available to use? (Choose two.)
- A. multipath HA
- B. quadpath HA
- C. single path
- D. mixed-mode
Answer: A,D
NEW QUESTION # 35
You installed a new pair of Cisco 92300YC cluster switches at a customer's site. Before you install any files on the switch, you want to view the current configuration.
In this scenario, which command would you use to accomplish this task?
- A. switchcfgshow
- B. fabricshow
- C. show running-config
- D. config show
Answer: A
NEW QUESTION # 36
You have an AFF A400 cluster that is running ONTAP 9.7 software. You are asked to set up FlexCache for NFS volumes.
In this scenario, which statement is correct when implementing FlexCache?
- A. A site license is required.
- B. No license is required.
- C. A subscription license is required.
- D. A capacity license is required.
Answer: D
NEW QUESTION # 37
In an ONTAP switched cluster, which three types of traffic travels over the cluster network? (Choose three.)
- A. Epsilon voting
- B. remote cluster peering
- C. intracluster SnapMirror
- D. cluster database replication
- E. intercluster SnapMirror
Answer: B,D,E
NEW QUESTION # 38
......
Prepare for the Actual NCSIE ONTAP NS0-184 Exam Practice Materials Collection: https://www.freecram.com/NetworkAppliance-certification/NS0-184-exam-dumps.html
NCSIE ONTAP Certified Official Practice Test NS0-184: https://drive.google.com/open?id=1JSJ6Zavg0UYTY1lN8e29lGe8G8ffl2s1