Exam 350-401 Topic 4 Question 609 Discussion

Actual exam question for Cisco's 350-401 exam
Question #: 609
Topic #: 4

Which command must be applied to R2 for an OSPF neighborship to form?

Suggested Answer: A Vote an answer

The network 20.0.0.0 0.0.0.255 area 0 command on R2 did not cover the IP address of Fa1/1 interface of R2 so OSPF did not run on this interface. Therefore we have to use the command network 20.1.1.2 0.0.255.255 area 0 to turn on OSPF on this interface.
Note: The command network 20.1.1.2 0.0.255.255 area 0 can be used too so this answer is also correct but answer C is the best answer here.
The network 0.0.0.0 255.255.255.255 area 0 command on R1 will run OSPF on all active

by Carr at May 07, 2024, 01:20 PM

Limited Time Offer

15%

Off

Get Premium 350-401 Questions as Interactive Self Test Engine or PDF

Comments

Chosen Answer:
This is a voting comment (?) , you can switch to a simple comment.
Switch to a voting comment New
Nick name: Submit Cancel
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
0
0
0
10