Exam FCSS_EFW_AD-7.6 Topic 5 Question 86 Discussion

Actual exam question for Fortinet's FCSS_EFW_AD-7.6 exam
Question #: 86
Topic #: 5
Refer to the exhibit, which shows an enterprise network connected to an internet service provider.

The administrator must configure the BGP section of FortiGate A to give internet access to the enterprise network.
Which command must the administrator use to establish a connection with the internet service provider?

Suggested Answer: A Vote an answer

In BGP (Border Gateway Protocol), a neighbor (peer) configuration is required to establish a connection between two BGP routers. Since FortiGate A is connecting to the ISP (Autonomous System 10) from AS 30, the administrator must define the ISP's BGP router as a neighbor.
The config neighbor command is used to:
Define the ISP's IP address as a BGP peer
Specify the remote AS (AS 10 in this case)
Allow BGP route exchanges between FortiGate A and the ISP

by s.bhagwnabali at Jun 27, 2026, 12:55 PM

Limited Time Offer

15%

Off

Get Premium FCSS_EFW_AD-7.6 Questions as Interactive Self Test Engine or PDF

Comments

Chosen Answer:
This is a voting comment (?) , you can switch to a simple comment.
Switch to a voting comment New
Nick name: Submit Cancel
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
0
0
0
10