Exam JN0-281 Topic 1 Question 30 Discussion

Actual exam question for Juniper's JN0-281 exam
Question #: 30
Topic #: 1
Within your router, you want to verify that you are learning routes from a remote BGP peer at IP address 10.10.100.1.
Which command would satisfy the requirement?

Suggested Answer: A Vote an answer

To verify that your router is learning routes from a remote BGP peer at a specific IP address (e.g., 10.10.100.1), the correct command to use is show route receive-protocol bgp.
Step-by-Step Breakdown:
BGP Route Learning:
The show route receive-protocol bgp command displays the routes that have been received from a specified BGP peer. This helps in confirming that the remote peer is sending routes correctly and that your router is receiving them.
Command Example:
show route receive-protocol bgp 10.10.100.1
This will show all routes that have been received from the BGP peer with IP address 10.10.100.1.Juniper Reference: BGP Route Verification: Use this command to troubleshoot and verify that routes from a specific BGP peer are being received.

by Owen at Jul 19, 2026, 11:49 PM

Limited Time Offer

15%

Off

Get Premium JN0-281 Questions as Interactive Self Test Engine or PDF

Comments

Chosen Answer:
This is a voting comment (?) , you can switch to a simple comment.
Switch to a voting comment New
Nick name: Submit Cancel
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
0
0
0
10